Electronics Forum | Wed Sep 11 12:52:14 EDT 2002 | slthomas
We have found that using the SPC capability of the profiler's pc software helps us identify oven malfunctions sooner than we would normally find it. The ovens tend to compensate for dieing or dead blowers by cranking the heaters on for longer cycles
Electronics Forum | Tue Mar 09 18:21:37 EST 1999 | Stan Levitsky
We will wave solder a board with SOIC14 and SOIC16 parts on the bottom. It has been difficult to find any specific wave solder process recommendations from manufacturers of the SOICs. The pad geometry utilizes theiving pads on both sides to reduce br
Electronics Forum | Tue Dec 04 09:48:43 EST 2001 | davef
Defining the thickness of solder between the lead and the pad, J-001 states "Properly wetted fillet shall be evident." J-001 is available from http://www.ipc.org. Factors that affect this are: * Amount and composition of solder * Amount and compo
Electronics Forum | Wed Aug 21 13:28:20 EDT 2019 | ameenullakhan
And what is the solder paste selection recommendation for the same. 1. Water soluble ( organic based flux solder based ) 2. No clean ( rosin or resin based solder paste ) customer is suggesting water soluble chemistry , which is having lot hot an
Electronics Forum | Fri Jul 06 12:11:34 EDT 2007 | james
We are starting to see issues with using Kester WS R562 with lead free components. The joints look grainy on almost all of the 0402'2 and other small components. Some of the solder does not solder to the terminations. These are hybrid boards which
Electronics Forum | Wed Jul 24 17:25:01 EDT 2019 | davef
Your solder stencil design should follow all basic rules for solder stencil design are followed in accordance with IPC-7525 including adherence to an area ratio of 2:3 or greater and an aspect ratio of 1.5 or greater.
Electronics Forum | Mon Jan 17 17:38:29 EST 2011 | bandjwet
All: I am reaching out to get some suggestions on the right flux to use as well as a recommended cleaning process for soldering a KOVAR RF shield using 80/20 Au/Sn solder to a ceramic hybrid. The recommended profile is 4-5 min at 280C and at least
Electronics Forum | Fri Jul 06 12:39:01 EDT 2007 | blnorman
What's the metallization on the board? We use an immersion tin board and had to increase our profile to successfully solder.
Electronics Forum | Wed Jul 24 10:07:44 EDT 2019 | ameenullakhan
Hi Team, Can anyone suggest me best stencil opening for CCGA. Attached is the component details. Solder paste : water solube - ORL0 - Jtsd 001 ( Sn63/Pb37) Any one has qualified the same. Regards, Ameen
Electronics Forum | Thu Jan 24 09:53:56 EST 2002 | davef
You didn�t tell us about your solder, wave temperature profile, or the distribution of the problem. So, let�s assume the solder is near eutectic and the problem is wide spread. Wolfgang makes good points. So, let's talk a different tact. When we