Electronics Forum | Thu Oct 24 15:02:16 EDT 2002 | seand
Hello Yannick, Have you brought this concern up with your supplier? I would recommend speaking with your flux and paste provider to gain additional insight and recommendations for resolving the concern. Good luck, Sean D.
Electronics Forum | Wed Nov 06 05:13:01 EST 2002 | Dreamsniper
Crystalline flux if it is really clear should not be a problem. We were using Amtech paste before and we have the same results. Sometimes we mistakenly see it as a dry joint because of the reflections from the lighting of our Metcal inspection system
Electronics Forum | Fri Apr 06 08:32:47 EDT 2007 | davef
Haris: On your soldering issues, we don't know the make-up of your component. We don't know the type solder balls on the component. We don't know the solder paste you plan to use. Your component and paste supplier are better sources for this type o
Electronics Forum | Tue Aug 09 11:56:01 EDT 2005 | Rob
We sometimes use a peelable mask the the PCB manufacturer (board house) adds as part of their process. It may seem an expensive option but avoids: Raising P/o's for tape/peelable mask as consumables booking & inspection Booking out to the shop floo
Electronics Forum | Mon Dec 16 17:35:43 EST 2002 | davef
Jim Consider issuing a purchase order to your assembler for the purchase of selective wave soldering pallets required to solder your board. That way, you: * Own the pallets. * Can take the pallets with you should you decide that another assembler
Electronics Forum | Sat May 15 11:27:26 EDT 2010 | davef
We'd expect both OSP poor wetting and improper reflow recipe to show-up in more places than just this one component. But if those are the only choices, we'll go for 'wrong solder paste.' Ooops, that's not one of the choices. Ok, OK, we'll take poo
Electronics Forum | Mon Dec 16 16:35:55 EST 2002 | Jim Ferris
Randy, Steve & all, Can you guys point me in the right direction when it come to using selective wave soldering...I am trying to get in-depth information on the Pro's & Con's of having our supplier use this process for our PWA's. (I can see there ar
Electronics Forum | Tue Dec 17 13:42:04 EST 2002 | robf
There are a few emerging technologies that have been growing in popularity for the past few years. Pin through paste, press fit connectors and selective soldering machines seem to be displacing custom fixtures. Most of the mixed technology boards o
Electronics Forum | Fri May 14 09:00:35 EDT 2010 | rafacadiz
I attached a RX picture. A lot of voids and micro balls arround the flux residue. What do you think, relow temperature reflow or OSP poor weeting.? I appreciate your comments. Thanks,
Electronics Forum | Tue Dec 17 08:38:30 EST 2002 | Randy Villeneuve
Jim, In most cases if you can eliminate a process you will save money. With that in mind, an all surface mount or all through hole design is prefered. There are alternatives to that rule, like hybrid designs that can be pin and paste soldered. It al