Electronics Forum | Wed Mar 10 13:53:13 EST 1999 | Vincent Vega
| We will wave solder a board with SOIC14 and SOIC16 parts on the bottom. It has been difficult to find any specific wave solder process recommendations from manufacturers of the SOICs. The pad geometry utilizes theiving pads on both sides to reduce
Electronics Forum | Wed May 26 10:00:03 EDT 1999 | David Scott
| | | | | | | | | | | | Any suggestions on how to maintain Adhesive dispensing nozzles??? They seem to plug up over night and it is starting to get on my nerves. We have tried leaving the nozzles in the machine, removing them and soaking in alcoh
Electronics Forum | Mon Aug 10 15:15:17 EDT 2009 | indity
I have very little knowledge of pick and place machines or assembly, and was hoping someone could give me some advice of where to start looking. I do learn quickly so I am not afraid of challenges or learning through mistakes. I need to produce abou
Electronics Forum | Sun Aug 31 16:16:37 EDT 2014 | spoiltforchoice
Andres, I think if you were to understand the process a little better you would realise the many many problems you would encounter building even very simple things using your method. Even 30 minutes watching Youtube videos of current machines might h
Electronics Forum | Tue Dec 08 12:44:52 EST 2020 | janwillemreusink
Who is using two sorts of tin in one selective soldering machine with to solder pots? So then the soldering program selects the correct pot (tin). What are the risks? Adding wrong tin in the wrong pot. Mixing up the nozzles?
Electronics Forum | Thu Dec 10 12:12:40 EST 2020 | robl
Yep, done it previously with a multipot machine. Using with wirefeed to top up the pots means you only have a contamintion risk when you fit a new top up reel. Used separate nozzles for both, but theoretically using titanium nozzles would mean no c
Electronics Forum | Tue Dec 15 14:38:23 EST 2020 | emeto
I have done it different ways on different equipment. 1. Remove alloy one from the machine. Add alloy two only. and use it.For next board, do the same. 2. There are machines with separate sections for PB and PC-Free, so pots are away from each other
Electronics Forum | Tue Dec 30 09:31:52 EST 2014 | rgduval
I've always approached it like this: Design your processes and perform your work to class three standards, and inspect to the standard that is acceptable. That is, all work should be performed to the highest degree of quality. When the work is ins
.gif)
