Electronics Forum | Sun May 28 23:01:31 EDT 2006 | jacksaria
Hello to all, We are encountered many problems/defects in SMT lines.I would like to know your suggestion or recommendation for SMT optimization and improvement. What are the step by step solutions in order to optimized and to improve the printer, pi
Electronics Forum | Wed May 31 21:33:52 EDT 2006 | jacksaria
Hello jbrower, Thank you for the feedback. Actually, our main problems is the pick and throw. Whats your suggestion how to control the pick and throw?What are the factors that affecting pick and throw?How to reduce the sources of variance at each st
Electronics Forum | Thu Jun 22 17:47:05 EDT 2006 | davef
First, we expect voiding in imm silver to be similar to ENIG. We expect more voiding in OSP than other common solderability protection. Second, choosing a solder paste, which does not contain resins and activators that decompose at higher temperatu
Electronics Forum | Tue Jul 11 10:13:22 EDT 2006 | SWAG
Over time, you might see problems with delam., blistering and warpage if using FR4 carriers. Depending on volumes, you might consider using durostone or some robust material like that for the production runs. Keep in mind that switching materials w
Electronics Forum | Thu Oct 04 13:34:02 EDT 2007 | rgduval
I'd be happy to tell my customers that they need to provide more parts...the problem is, we specialize in short runs. So, if the customer pinches pennies, and only buys 50 pieces for 50 piece demand, I need to be able to deal with it. Hence, the
Electronics Forum | Tue Jun 05 20:36:01 EDT 2007 | rfrog
LarryP, ESD smocks in combination with a wrist strap provide a path to ground for any charge potential. An operator wearing a smock while grounded will provide a path to ground for the chair. With an ESD chair you can have antistatic or static
Electronics Forum | Wed May 07 15:36:04 EDT 2008 | llaerum
The 483 is what we use on all boards except on one where the 353 improved wetting on resistor packs. It worked much better since the parts are LF and this is the same flux AIM uses in their LF solder. Yes, it was recommended by AIM when we discussed
Electronics Forum | Wed Sep 24 11:43:15 EDT 2008 | pgarsoe
I'm not sure this would solve your problem but Inovaxe has done a good job of solving MSD and inventory handling and control. They are also a sponsor of SMTnet...here is their SMTnet listing followed by thier web site for their carts... http://www.sm
Electronics Forum | Thu Mar 18 18:52:29 EDT 2010 | edwaterfall01
There is a retrofit kit to take care of the head cable problem that you mention. The s/n with 7P in it represents what is called the 7 Plus level of the head. There was one more level after that (09) for the GSM. The better heads mentioned in the
Electronics Forum | Wed Jul 19 07:27:09 EDT 2023 | roachindignant
This problem appears whenever I turn on my UP2000 HiE printer and try to perform the initial Reset. Hardware Limit Warning (E00938:10) All sensors on the Input/Output Screen are functioning appropriately and will give expected results when checked