Electronics Forum | Thu Nov 03 14:43:19 EST 2005 | chunks
Hmmmm.... We never had to change any parameters when switching over to Gels. And no, we don't let the operators have kitty-wampus on our programs either. The Gels did get rid of broken parts. We have Run Orders of about 50 pieces. We change over
Electronics Forum | Fri Jun 24 08:47:14 EDT 2005 | grantp
Hi, There are many aspects to consider. 1. Firstly the room needs to be designed so it's sealed, so linoleum floors than curve where the wall meets the floor, so dirt does not get trapped in the corners, and mops get all dirt and pick it up. Floor
Electronics Forum | Mon Aug 17 02:50:44 EDT 1998 | Bob Willis
| Have an SRT w/preheat, 18 layer board all copper, 456 BGA needs to be removed and replaced. The manufacturer is Chip Express and during reflow it warps up or down. Causing either opens or shorts on the corners. I was using gel flux with multiple