Electronics Forum | Thu Jun 28 22:20:23 EDT 2012 | davef
John: Secure the capacitors that you removed from the machine ... * Removed capacitors have a problem * New replacement capacitors don't have a problem Find help to determine the difference between the two reels of parts
Electronics Forum | Thu Jun 28 09:57:50 EDT 2012 | mosborne1
blow holes and via holes are almost always caused by moisture and in PTH they could be moisture and improper drilled holes. If you are seeing solder balls next to the parts than I would say you have a reflow profile problem. Are you using any kind of
Electronics Forum | Thu Jun 28 16:43:51 EDT 2012 | ssupertuba
Yes I have a KIC and have checked the profile often. I just changed the reel of the parts that are causing problems and it went away. Now what am I suppose to say? I have made an NCMR for the parts but I'm sure they would work in an environment of
Electronics Forum | Thu May 30 09:33:15 EDT 2019 | emeto
Contributors in order of importance: 1. PCB design - if you have large thermal pads, a grid of via holes should be created. Components with low profile will not let the gas to escape from the joint. The only way is going down. 2. Reduce paste volum
Electronics Forum | Mon May 06 06:22:39 EDT 2019 | SMTA-Rogers
Hello! Do you have a better stencil design to reduce the large area of solder joint voids? Or is there a suggested way to set the reflow profile? Or are there other process improvements to make the solder joint at the LED pad less than 10% per void?
Electronics Forum | Mon May 06 11:45:32 EDT 2019 | slthomas
There are quite a few papers out there on the subject. Just enter "SMT void reduction" into google or other search engine and take your pick. That said, slow ramp rates and paste volume reduction are a good place to start. Although I haven't tried i
Electronics Forum | Thu Feb 18 17:35:43 EST 2010 | haider
What do we need to fix in the profile if we have voids in BGAs?
Electronics Forum | Mon Feb 22 16:24:52 EST 2010 | blnorman
Depends on how much voiding you have as well. 25% is allowable.
Electronics Forum | Tue May 07 10:13:06 EDT 2019 | cyber_wolf
I have personally never seen a reflow profile change reduce voids. We have invited "experts" in to demonstrate this claim. They were unable to.
Electronics Forum | Mon May 27 04:28:30 EDT 2019 | SMTA-Rogers
Dear Steve, Thanks for your feedback in our experience add solder paste volume is better for the voids reduce of LED type components.
.gif)
