Electronics Forum | Mon Oct 03 11:33:09 EDT 2011 | artposada
I have been getting solder balls on the leads of a transformer that I am soldering to my pc board. My parameters are listed below. The board PTH's are .039 The transformer leads are .0255 square. My solder pot temp. is 310C Solder is Lead Free AIM
Electronics Forum | Wed Mar 28 20:35:52 EDT 2007 | darby
Quadalign is very similar to the Samsung. I would think that 4% dump on 1206 or even IC is way over the top. If you are certain that your component data is correct; I suspect that your z-axis centring height may be out of whack and that you are eith
Electronics Forum | Wed Oct 25 12:38:05 EDT 2000 | Phil
Hi there!! You know what your QA is doing is right, coz by measuring the solder paste height can avoid the following defects: 1.Insufficient solder 2.Short solder or bridging 3.Solder balls SPC monitoring for paste height checking is required
Electronics Forum | Fri Aug 07 09:53:12 EDT 2009 | kpm135
The Z-axis Drive card on our MPM UP2000 HiE fried. We replaced it with a new card, setting all the jumpers to match the old card. After that we had to recalibrate the Z-axis and the snugger height but the problem is that the camera is now too close t
Electronics Forum | Sat Sep 02 15:54:46 EDT 2023 | mekmat544
Hello, I would like to ask you for help. We have problem with our Selective Solder System SEHO PowerSelective. Problem is, that Z axis is decreasing. When we start soldering, height of Z axis is correct but after each solder cycle, there is decreasin
Electronics Forum | Sat Jun 12 10:46:32 EDT 1999 | Dean
| Our company is experiencing cracked caps at our pick and place operations. The caps are being placed onto epoxy dots for subsequent wave solder operations. At present, be have set the pressure of the head at 2 in/lbs. This being down from manufac
Electronics Forum | Wed Aug 23 11:06:57 EDT 2017 | cyber_wolf
Bad Z-force sensor or it is checking the board height in a hole.
Electronics Forum | Wed Feb 16 09:44:09 EST 2005 | beta
Check to see if its the same component everytime if so check part height . Also check Z0.This setup is in the manual. You say this only happens after maintenance is carried out so when you free the nozzle it doesnt happen again until maintenance is
Electronics Forum | Mon Jan 24 12:27:20 EST 2005 | dougt
At the risk of siding with gregp....... I like how this machine looks http://www.contactsystems.com/C5s.htm Rather than read about this machine from people who have never used it I would like to have someone who has seen it run please give an hones
Electronics Forum | Thu Jul 05 10:45:01 EDT 2001 | dougie
Steven, There is a load of info on this if you check through the archives. Quick pointer though are: Solder balls are caused by paste creeping under the component at placement. The part is placed and the paste is squashed under the component, when t