Electronics Forum | Mon Sep 28 11:30:14 EDT 1998 | Bob Barr
No, $60K is for the DRS-24 which has replaced the DRS-22. The 24 adds more bells and whistles, like motorized Z axis. I think they are pricing themselves out of the market, although I understand they are offering a stripped down 24 which is essenti
Electronics Forum | Wed Oct 06 09:23:51 EDT 2004 | mikecollier
The sampling rate on the KIC software can be changed by the user. The default setting is a sample rate of 60 seconds, so that, every 60 seconds the "old" measurement is subtracted from the "new" measurement to calculate the slope (i.e., start temp i
Electronics Forum | Mon Jun 12 13:49:47 EDT 2006 | grantp
Hi, Thanks guys for all the suggestions. I am going to check what options we have for top side heating. Do people recommend we get convection for that? Also, we seem limited to 60% in the machine setup, and does anyone know how to run the top lam
Electronics Forum | Wed Apr 16 11:29:31 EDT 2008 | mmjm_1099
Per Tony SMT Here are more photos: Q15, Q16, Q17 represent good transistors on a 1 up board with the transistor locations that are in question. Q13 is a good transistor on a bad 2up board. Right next to it is Q14 a bad transistor on a bad 2 up boa
Electronics Forum | Fri Aug 28 08:52:13 EDT 2009 | duso02
Yes, you must thin Dow CC for any spray operations. We use Dow 2577 daily for multiple customers and we always thin it for spray operations and 2577 is considered medium viscosity. Dow recommends using up to 60% solvent (Xylene). Your 2620 is low vis
Electronics Forum | Wed Aug 07 15:41:28 EDT 2013 | simplycomplex85
Absence of solder is just black/super dark red which still falls under any percent I could put in there. So it passes. Maybe I'm a bit confused on how the machine checks solder in general anyway... 0%-60% is a pass by default. Thats anything dark - s
Electronics Forum | Tue Jun 05 02:10:01 EDT 2018 | buckcho
Hello sir, Limits in SPI can vary a lot, also depending on finishing of the pcb. For example 170% volume on an IC (assuming is fine pitch) can be okay for ENIG, but very bad if HASL. For are I would recommend that you use either 50-130, or 60-135 max
Electronics Forum | Tue Feb 15 14:25:08 EST 2000 | Sergey
Dear Sirs Good business day! I need the following feeders for CSM60 machine: - Stick feeders: 1. 20 mm x 1 2. 13 mm x 3 3. 8mm x 7 - Tape feeders: 1. 16 mm, 9" x 7 you seems to be have not this 2. 24 mm, 9" x 3 3. 32mm, 9" x 1 - Manual tray feeder
Electronics Forum | Thu Mar 23 00:37:47 EST 2000 | Donnie DeYoung
Thanks guys. We are currently using an Opti Flux fixed spray head at 10 to 20 psi. We were using the 351 flux at 60 psi before this, so as you can see we found that there's a huge difference here. We are currently running a conveyor speed at 5.0 FPM.
Electronics Forum | Thu Mar 15 09:30:01 EST 2001 | keith47611
We've actually seen best results with 60 degree blades (as measured from stencil surface to face of blade), and paste sticking has not been a problem since we switched to a higher quality metal blade. More expensive than the OEM stuff but worth it.