Electronics Forum | Sun May 31 11:14:48 EDT 2015 | visionbot
Looks good. Have you done any work on feeding > form part tubes? I have a back burner project > trying to speed up the changover on our machine > with the vibe feeders. VisionBot works with cut tape SMT, is not necessary to have advanced mechani
Electronics Forum | Wed Apr 28 15:18:17 EDT 2021 | dilogic
24V feeders are very simple to interface. You have supply voltages (24VAC, 12VDC), status output and control input (advance). All signals are using 12V levels. To advance feeder pull control input to GND. Connect status output to +12V with a pull-up
Electronics Forum | Fri Mar 03 13:41:43 EST 2000 | pr
Is it o.k. to clean my glue stencils in the same IPA stencil cleaner I use for solder paste? Also if anyone with experience in stenciling glue can lead me away from first time pitfalls I would appreciate that as well. thanks in advance
Electronics Forum | Thu Mar 02 04:36:43 EST 2000 | ken fong
Could anyone advise the top three soldering materials providers (providing solder bars, solder paste, solder wire and flux) in each of the following regions : USA, Europe, and Japan? Thanks in advance. Regards, KenF
Electronics Forum | Wed Feb 23 16:25:33 EST 2000 | John
We are using a glue and wave solder process for primarily chip components. Our products do not use any fine pitch components. What would an acceptable benchmark for the placement defect rate be? 50 DPMO? 100 DPMO? 200 DPMO? Thanks in advance,
Electronics Forum | Fri Dec 15 12:08:26 EST 2000 | Alex B.
i'm going to try placeing 0402 with a fuji IP2. Will i have any problems and are there any sugestions thanks in advance Alex B
Electronics Forum | Wed Dec 06 15:22:07 EST 2000 | Christopher Lampron
Does anyone know of documented inspection criteria for inspecting BGA's post reflow? (e.g. void percent, alignment, etc..) Any help would be greatly appreciated Thanks In Advance Chris
Electronics Forum | Fri Dec 01 08:48:45 EST 2000 | Michell Sanchez
Hello everyone, thank you for taking the time to read this. I am currently looking for 40 solders to work in south Florida. If anyone has any friends or family that would be interested please E-Mail me @ msanchez@Onsite-inc.com. Thank you in advance
Electronics Forum | Tue Nov 14 04:17:22 EST 2000 | Mohammed Saad
Hi, I need some information about the relation between the type of flux used in wave soldering and the quantity of dross produced. Thank you in advance for your help Mohammed
Electronics Forum | Wed Oct 11 13:15:26 EDT 2000 | T.A.
Does anyone know were I can get the number for EMC stencil cleaner. I need technical books for an EMC 30S stencil cleaner.. Thanks in advance. T.A