Electronics Forum | Thu Nov 06 13:44:15 EST 2003 | moncav
Does anyone know where I might find an AP25~27 or UP2000 series printer for very low dollars? It would be nice if all of the parts are there (or not) and does not need to be operational. Thanks, Charlie
Electronics Forum | Thu Nov 06 13:44:18 EST 2003 | moncav
Does anyone know where I might find an AP25~27 or UP2000 series printer for very low dollars? It would be nice if all of the parts are there (or not) and does not need to be operational. Thanks, Charlie
Electronics Forum | Tue Feb 17 15:38:18 EST 2004 | cyber_wolf
I agree with dry wiping. We have 4 SPM's and 2 AP25's, we have never had a need for solvent. I would be cautious using alcohol/ or alcohol based solvents.
Electronics Forum | Fri May 21 14:51:29 EDT 2004 | cyber_wolf
The sprayer is supposed to be aimed at the part of the wiper paper that comes in contact with the stencil.(Not @ the stencil) We have 4 SPM's and 2 AP25's and never had a need to use the solvent sprayer. Dry wiping works just fine. Print on !......
Electronics Forum | Mon Jul 26 23:09:08 EDT 2004 | simmcircuits
Thanks Paul, yes the camera seems like it needs thru bore calibration. Any instruction on how to conduct thru bore calibration? Thanks.
Electronics Forum | Tue Jul 05 05:23:34 EDT 2005 | kentes
We have one set MPM AP25. Its prestop position is not stable,but stop position is stable. It often occur "time out" alarm when load PCB.Which one can help us.
Electronics Forum | Wed Jul 06 10:22:04 EDT 2005 | PWH
At times we have had this problem with our AP25 due to one of the conveyor belts slipping. Load a PCB and check to see that both conveyor belts are running at the same speed. If not, tighten the one that is dragging. Hope this helps.
Electronics Forum | Fri Oct 28 09:27:36 EDT 2005 | russ
havfe you tried all paste manufacturers? Dog ears are usually from a little sticking to the aperture walls. this is usually the result of stencil design and or table seperation speed.
Electronics Forum | Mon Oct 31 03:32:45 EST 2005 | pavel_murtishev
Good day, We are using dedicated vacuum tooling. I can�t turn off the vacuum because board will not be fixed at all. BR, Pavel
Electronics Forum | Mon Oct 31 03:35:41 EST 2005 | pavel_murtishev
Good day, I simply switched the production from MPM to other printing machine. Defect disappeared. Process parameters and process materials were the same. Stencil was the same. �Dog hides� somewhere in the machine. BR, Pavel
