Electronics Forum | Mon Jul 26 18:27:59 EDT 2010 | fredc
We make these also. Our nozzles are available as medium hard from heat treated bar (32 to 38RC) or very hard made from Bearing Quality 416 stainless. We can retip your Fuji nozzles also. www.nozzlesupply.com
Electronics Forum | Thu Sep 02 15:03:57 EDT 2010 | ccouture
a quick search on "life expectancy of linear bearings" will give you a clue on how any pick&place machine performance will decline with time. It's measured in distance travelled. So the more you use them, the more they wear out, the less precise the
Electronics Forum | Tue Sep 07 11:04:44 EDT 2010 | mikesewell
Looks like a hand solder process - getting paste down but not smearing it too bad while sliding the connector on is probably not worth the trouble. Teka makes solder bearing connectors which would allow you to install last and simply reflow with the
Electronics Forum | Thu May 12 16:23:00 EDT 2011 | vickt
Is this a consistent issue? Have you tried running in "step mode" to see if it's really a handling related issue (ie Clutch, bearings, etc)? Good Luck
Electronics Forum | Sat May 11 15:43:55 EDT 2013 | anvil1021
Hello Again...SMTNET....are there rules to determine which small BGA devices are Dip Fluxed or Solder pasted? What drives the decision? Obviously the device's pitch has a large bearing on this decision. Any and all comments or experiences would be ve
Electronics Forum | Fri Aug 30 07:27:21 EDT 2013 | duso02
Contact the coating manufacturer to get their response. We use many different coatings every day and they all glow differently but that has no affect on the coating itself. As stated earlier, it's job is only as an inspection tool to identify where
Electronics Forum | Sat Feb 15 13:06:00 EST 2014 | bobpan
This is a theta axis head 2 error. Manually spin the head and make sure the bearings are loose and spinning. If not, they may need lubricated or serviced. You can also swap theta amps between the heads to see if you have an amplifier problem. Good L
Electronics Forum | Wed Aug 06 22:36:27 EDT 2014 | padawanlinuxero
Not an expert, so bear with me, but I think that depends on how much components are in the vicinity of the pads you want to step. Hope this pdf helps Cheers!
Electronics Forum | Thu Apr 02 10:50:24 EDT 2015 | fnorradd
Hi All, Does anyone have any companies where I can purchase all the spares for JOT conveyors. Bearings, belts, motors, etc. Any feedback much appreciated.
Electronics Forum | Fri Aug 05 13:34:03 EDT 2016 | dphilbrick
Spoke the ladies here a couple years ago, they still will make them for you Bear Wear Inc. 1114 Spring Creek Lane Lewisville, Texas, 75067 USA Phone 972-315-6457