Electronics Forum | Thu Dec 17 09:34:05 EST 2009 | pfifla1
does anyone know of a place to purchase a kit to repair or make replacement belts for PCB conveyors? it would be convenient to make vs. repair. they are just the standard rubber conveyor belts.
Electronics Forum | Wed Jul 13 14:24:43 EDT 2011 | leemeyer
Look at http://www.habasit.com. They sell the belt and the tools to cut and join the ends. I remember looking into this several years ago and the cost of the tooling was so high that it didn't make sense for us to make our own belts.
Electronics Forum | Wed Oct 03 13:04:13 EDT 2012 | roison
Comtra system take over by RoiSon Technology ,they still build Belt Feeder and repair any Comtra belt feeder ,,spare part. there phone 763-639-1921 Email phipho11@hotmail.com
Electronics Forum | Wed Oct 03 13:19:34 EDT 2012 | roison
Comtra system take over by RoiSon Technology ,they still build Belt Feeder and repair any Comtra belt feeder ,,spare part. there phone 763-639-1921 Email phipho11@hotmail.com
Electronics Forum | Mon Nov 25 11:55:39 EST 2013 | emeto
Hello all. I am looking for a belt feeder for my Siemens machines. Who is making good belt feeders? Please list some companies that manufacture these.
Electronics Forum | Tue May 14 20:45:45 EDT 2002 | davef
Ashok Dhawan, an old friend of SMTnet, says: Formula for counting components on SMT tape & reels [spiral belt]: Length = Number of turns * 1/2 * 22/7 * ( dia outer + dia inner), where ... Number of turns = ( dia outer - dia inner) / thickness of
Electronics Forum | Thu Feb 09 09:18:22 EST 2012 | swag
I'm not familiar with Quad but I have had very similar problems on printers. If your conveyor has an L-bracket over the top of the conveyor belt to keep it down + aligned, you might need to remove it for cleaning or make some adjustments to it so it
Electronics Forum | Wed Sep 26 11:18:21 EDT 2012 | swag
You have to loosen the tension on both sides of the drive belt and skip a tooth or two until the cenveyor is parrallel. You'll have to grip the belt tight on one of the drive gears then force the other gear to rotate inside the belt on the other end
Electronics Forum | Wed Feb 08 09:21:03 EST 2012 | ngineer
What Should I use to clean a sticking conveyor > belts in my pick an place machine (Quad IVc)? > The belts seem to have what I would guess to be > solder paste that is dried, but also they seem to > be a bit gunked up as if they had gotten some o
Electronics Forum | Thu Jun 04 14:47:31 EDT 1998 | Leo van de Vall
We have been selling belt feeders for many years and they perform very well. Larger components can be picked very reliably; setup is easy. The only disadvantage is that for smaller components like SO8, SSOP or any small component that is square or a