Electronics Forum | Mon Feb 12 11:13:12 EST 2007 | davef
Q1. If I go to the Pb-free solder paste, is it necessary that I have to change my reflow oven OR just by changing with respect to solder paste specification, I can reach my goal? A1. It depends on your current oven. Some ovens can meet the higher t
Electronics Forum | Sat Dec 30 04:23:50 EST 2023 | 012band
I have used LTS (Sn57.6%Bi0.4%Ag) solder balls for soldering on Ni/Au pads, and I have observed a wrinkle pattern on the ball surface. When you attempted soldering on CuOSP substrate pads under the same conditions, the surface appeared normal. Additi
Electronics Forum | Tue Feb 27 18:16:42 EST 2001 | davef
I have never seen excess tin [heard of it, just never seen it]. Excess lead yes, but tin no. See, tin oxidizes faster than lead. This means that dross has a higher tin content than the solder in the pot. So, with a very high dross machine, we regul
Electronics Forum | Wed Aug 15 16:04:23 EDT 2001 | davef
First, responding to your question � Several things on copper dissolution in solder are: * A 50um copper wire will dissolve in 60Sn / 40Pb solder at: - 200�C solder in 55 seconds; - 250�C solder in 20 seconds; - 300�C solder in 5 seconds; - 350�C so
Electronics Forum | Fri Aug 30 16:25:21 EDT 2002 | davef
Imm silver holds-up to multiple thermal cycles very well. The things, we guess, are happening to make imm silver tough to solder after heating and sitting are: * Oxidation of the silver. * Reduction of the co-deposited organic anti-tarnish [used in
Electronics Forum | Wed Dec 15 16:38:42 EST 2004 | patrickbruneel
Here's my 10 cents Studies done in the 1980's concluded that pure tin was prone to whisker generation. A tin content lower then 70% became exempt from this phenomenon. I have never seen or done any studies on the impact lead had in reducing the pote
Electronics Forum | Wed Jan 11 18:44:42 EST 2006 | fctassembly
Hello Greg, Glad to hear your success with the SACX0307 copy. By the way, does the P mean it contains phosphorus? Does yours also contain bismuth like the SACX0307 (according to their plumbing solder patent for X0307)? In response to your discussion
Electronics Forum | Thu Jan 11 22:01:09 EST 2007 | davef
Joe: I know this is not the correct forum to post chip "reworking" questions. Reply: Rework questions are as appropriate as the next topic here on SMTnet J: BGA will not reflow at any normal temperature level. I believe these chips may have been gen
Electronics Forum | Sun Jan 14 12:42:35 EST 2007 | SMTRework
I think the main cause of this condition is #3 because both #1 and #2 never change from board to board, these are identical boards with identical BGA revisions. These BGA's (as stated before) are about 3 years old.. I don't believe they are lead free
Electronics Forum | Tue Jun 24 13:46:21 EDT 2008 | bschreiber
I know it is not what you want to hear, but first and foremost, you must consult your local regulating agencies and here is why: Solder paste contains heavy metals. We are all familiar with the problems associated with lead, but lead free solder pas