Electronics Forum | Sun Aug 18 21:06:45 EDT 2019 | dman97
Based on the fuji error codes, It says that the ARCNET cable is disconnected. Make sure that all cables from this module are connected to the QP.
Electronics Forum | Fri Feb 16 21:51:15 EST 2024 | jborrelli76
I was correct...the cable that operates the stencil clamps on the right bank is severed...do you know where I can get a replacement cable part number 163368? Thanks.
Electronics Forum | Fri Apr 30 01:11:00 EDT 1999 | Dean
| We will be moving our entire plant in a couple of months . We are in the process of installing communication cable etc, to allow for a easy drop machine in line type move. ( is this possible) | My question is what type of communication cable would
Electronics Forum | Sat Sep 30 10:04:39 EDT 2006 | daxman
I found this pot, and tried adjusting it. It was already turned to its maximum, and the histogram did not look good. I tried replacing the board lamp and this helped the histogram a lot, but I am not able to get the bars centered in the green. The
Electronics Forum | Thu Jul 25 16:20:59 EDT 2019 | bobpan
Top red led is on or off depending on version of tep board. The green leds light when the transport sensor that it communitcates with is seeing a board over it. Tep controller init failure can be one of the following. 1. Check reseat tep card and
Electronics Forum | Thu Apr 29 14:16:58 EDT 1999 | Kevin Simpson
We will be moving our entire plant in a couple of months . We are in the process of installing communication cable etc, to allow for a easy drop machine in line type move. ( is this possible) My question is what type of communication cable would be
Electronics Forum | Sat Mar 24 00:08:55 EDT 2007 | mika
Fully SMPI (there are 2 kinds of SMPI and Universal used them both in the past). Converter cables between SMPI > Fully SMPI Converter cables between FUJI > Panasonic Converter cables between FUJI > SMEMA Converters between almost any machine interfac
Electronics Forum | Mon Mar 03 13:56:15 EST 2008 | daxman
Resolved! Jeeze...just after I posted this question I got the machine working. Someone had removed the cable for the wide camera and connected it into one of the ports that is unused. I noticed this when looking at the schematic. The cables had
Electronics Forum | Tue Dec 02 02:11:39 EST 2008 | raranchado
We're using a PFC (Product Flow Controller) box by Cogiscan between a conveyor and Agilent SJ-5000 (AOI) and the problem we're having is that when the downline smema cable is connected to the PFC box, the AOI conveyor belt keeps on turning even with
Electronics Forum | Mon Dec 20 10:53:41 EST 2010 | remullis
I started swapping motor cables and sensor cable doing a process of elimination and never found a problem, I put everything back to original and it homed. I not sure if it was a connection issue or it was a sequence of homing the machine needs to do
.gif)
