Electronics Forum | Fri Dec 30 11:35:16 EST 2016 | emeto
Thank you all. It was a bad connection. Everything is running fine. Happy new year to everyone! Emil
Electronics Forum | Sun Jun 14 19:41:35 EDT 2020 | yakout
hello michal have a nice day i need to adjust the pitch from 4mm to 8mm
Electronics Forum | Mon Jun 15 23:19:38 EDT 2020 | kylehunter
You literally just loosen both hex bolts and slide the bar to the pitch you want. Then tighten the bolts. You can also remove the bar, and flip it over to get additional pitches.
Electronics Forum | Mon Jun 23 19:33:09 EDT 2008 | adamcrum
Hello, I have a Philips Assembleon Topaz (not an X or XII, just Topaz), that we got from a broker or what have you. I just did a complete rebuild of the head assembly after some of the shaft bearings went out and was getting ready to do the auto moun
Electronics Forum | Thu Apr 13 17:34:43 EDT 2006 | gencinas
We have been using this new jig for almost a year now, and I can tell you, there is a big difference in our CP's performance before and after the use of the jig. We run a lot of 0402 and 0603 parts. Our downtime has decreased since the very first day
Electronics Forum | Thu Jan 26 20:12:46 EST 2012 | gaz
We have a thermocouple that is basically some tc wire plugged into our reflow oven. The oven converts these voltages into the readings, but are all K type thermocouple wire the same, so would have the same exact same values sent to the ovens cpu? I
Electronics Forum | Wed Dec 20 22:54:28 EST 2006 | fastek
I think that in this day and age.....if you are not testing the feeder via some sort of indexing proceedure while the feeder is off of the machine.....you are simply not going to be certain the feeder is working properly. The Alternative SMT jig do
Electronics Forum | Sun Jun 17 23:04:16 EDT 2018 | jandon
Nice! Place it in jig holder larger holes upward and start calibration. This calibration block is only for the laser heads. Calibration block E5190729000(white dot in the middle of the block) is also for the camera.
Electronics Forum | Thu Apr 15 11:53:37 EDT 2004 | Claude_Couture
Hi everyone, Our QC manager is bugging me about calibrating the TC readings on our reflow ovens. I keep telling him that doing a regular reflow profiling with a mole is sufficient to see if the oven temperature are normal. The manuals state that TC c
Electronics Forum | Thu Apr 15 16:33:40 EDT 2004 | wgaffubar
We never really use to calibrate the thermocouples on our reflow oven or wave solder systems, but we did disconnect the T/C's and input a calibration standard to check that the computer cards were correctly reading the proper temperature for a given