Electronics Forum | Fri Jun 04 00:30:58 EDT 2004 | valuems
Hi This Pig stuff sounds funny, but from my pass experience with what people are buying now days, you will get more orders than you can handle. You can sell some of these people any thing. As long as it is cheap they will buy it, even if it won't
Electronics Forum | Mon Sep 27 10:23:38 EDT 2004 | grayman
Dek is the best machine for me.They have excellent support and the best features. However, if you are having problem with cost you get the Ekra. I know they sell it cheap as few buys it. Arman
Electronics Forum | Tue Oct 05 22:36:37 EDT 2004 | fastek
Who can blame anyone for having lousy service in China when there's twenty companies selling cheap throw away ovens for $20K new. What's surprising is why would BTU, Ersa, Vitronics and Heller even try to sell over there anymore.
Electronics Forum | Wed Oct 13 10:23:20 EDT 2004 | tommyttr
Stefan, Have your tried buying them Aerotek in Germany? I have gotten stuff through them pretty cheap. How are you doing? How is business?
Electronics Forum | Tue Jan 04 21:21:57 EST 2005 | davef
Scotty: If you have excess CNC machine capacity, it might be economic, but if your machine and design resources are loaded-up the $1000+ sounds cheap. [Just another voice screaming in the dark.]
Electronics Forum | Thu Jan 06 10:56:32 EST 2005 | Rob
If the Leds are not in close proximity then LDR's can be used connected to a node on the ICT/wired into a micro for a simpler board - you can then test for luminous intensity as well as absence. Else you could use a cheap CCD camera with some simple
Electronics Forum | Thu Feb 10 09:13:10 EST 2005 | russ
cap and resistor Parts are cheap! $10 vs. $20 or so? If you are worried about inventory cost than only buy your top 10 or so runners in the large reels. I am a big fan of large reels for the high running caps and Resistors.
Electronics Forum | Thu Apr 07 08:57:06 EDT 2005 | blueflag
have been through somethings with an engineer on the help desk and the concusion is that it is the z motor with the encoder that is causing the fuse to go so have ordered another. Not cheap though at nearly �500. Thanks very much for your help, it
Electronics Forum | Mon May 09 11:43:04 EDT 2005 | paulhaines2000
We use a "McDry" cabinet for humidity control of opened, moisture sensitive parts. Relatively cheap and works good. This cabinet is installed right on the SMT line. Check out: http://www.seikausa.com/products/mcdry/
Electronics Forum | Sat May 14 13:07:42 EDT 2005 | gc
We have surge suppressors on every machine we have as well as suppression on the mains coming in the building. The power in the area has always had too much noise and we did have losses due to surges during storms and such. Three phase surge suppre
