Electronics Forum | Wed Dec 12 20:28:29 EST 2012 | davef
OSHA regulates eye protection under 29 CFR 1910.132 I've had inspectors confirm that eye protection was ANSI Z87.1 compliant, but have never had anyone question the level of protection provided by side shields.
Electronics Forum | Fri Jan 04 10:39:37 EST 2013 | dontfeedphils
We've got used MPM Accuflex that we recently purchased and it seems like the stencil to board offsets need to be calibrated. After looking into the manual it looks like it requires a fixture or calibration jig, can anyone confirm this? Does anyone
Electronics Forum | Thu Mar 14 18:16:58 EDT 2013 | isd_jwendell
With those interlocks tested, and confirmed good. I would check the end-of-travel safety switches next. It may think that the head is at the end of it's travel.
Electronics Forum | Mon Mar 25 14:41:50 EDT 2013 | markhoch
Just a thought, but have you pulled the datasheet for the part and confirmed that the plating on the leads is compatible with your current process/profile?
Electronics Forum | Fri Aug 23 03:32:12 EDT 2013 | pradeep_selec
Can anybody help & confirm the Humidity & Temperature Range to be maintained on SMT SHopfloor according to the IPC standard & its IPC standard number. Also the ways to compensate the humidity if its out of range; low cost / natural method.
Electronics Forum | Wed Nov 27 13:07:07 EST 2013 | processman
Hi, Can somebody confirm the correct operation of the rear clamp rails on an Ersa Ecoselect 2.... Do they only activate when the PCB comes into the machine then release, or stay activated thru out the flusing, heating, soldering etc
Electronics Forum | Wed May 21 03:59:05 EDT 2014 | aj
Hi, If you can advise any assembly issues or concerns regarding this type of part and also... 1 - Can you confirm that they come in tape & reel format? 2 - Is it a requirement to have a glue dot in the centre of the pcb pads? Thanks, AJ...
Electronics Forum | Tue Jun 24 15:11:32 EDT 2014 | davx
Ok...so I think this is a BAS16W manufactured march 2003, can anyone confirm this?
Electronics Forum | Wed Jul 15 16:34:30 EDT 2015 | pmcg
Anyone have any pointers on how to measure the purity level of the gas supplied to Selective Solder machines? We use both bottled gas and also have an N2 generator and would like to confirm that both are performing similar.
Electronics Forum | Sat Nov 07 13:32:50 EST 2015 | jimmyboz
Oh, IP2, holder 3 is not making the sensor that confirms it is up far enough for the X2 to move. It may even be just timing.