Electronics Forum | Tue May 26 20:18:09 EDT 1998 | Justin Medernach
| | | | I'm reviewing my board fab spec. It calls for a minimum SnPb thickness of 50 microinches on HASL PWB's. I've looked at other specs that call out anything from 30 to 80 microinches, and others that just say the copper pad must be covered and
Electronics Forum | Fri Dec 15 08:00:57 EST 2000 | Pete B
John, We regularly wave solder electroless silver finished boards (Alpha Level)with mixed SMD and through hole parts and do not have any problems. We have changed a number on PCB's from HASL to electroless silver, mainly for the benefits at SMD whe
Electronics Forum | Mon Aug 03 08:23:37 EDT 1998 | smd
Stevens Products (supposedly around since 1937) 128 N. Park St. E. Orange, NJ 07019 Tel 973-672-2140 Contact: Ross Stevens, Jr. They'll take a PO but terms are net 30 Right now we are taping the goldfingers which is | effective but also expensive. A
Electronics Forum | Tue Apr 03 22:03:18 EDT 2001 | davef
With friends like you, who needs enemies? I�d guess that the perceived benefits of flat pads for your 20 mil pitch and below components counter-balance the higher cost, gold being a solder pot contaminant, limited solder mask compatibility, potentia
Electronics Forum | Fri Jan 02 16:52:16 EST 2009 | boardhouse
Hi, From a Manufactures choice - Green is the best due to it is the most commonly used mask color in the industry & cheapest. Kind a like Red paint for Barns. For US shops, most only have one LPI machine and to continually switch from Green to othe
Electronics Forum | Tue Oct 26 08:17:54 EDT 1999 | William
Dave, Last question(s). What do I do about a gold porosity problem? Dave: How would I approach the board house to check for this? They use a very well known chemistry, but is that where the pblm lies? Or would it be in their process, cycle times
Electronics Forum | Fri Nov 13 23:33:33 EST 1998 | Kallol Chakraborty
| | | I believe that gold fingers on my circuit boards are being | | | contaminated and need to clean them with some chemical | | | solution. Any recommendations. | | | | | Chuck: What is the type and source of your contamination? Dave F | | We a
Electronics Forum | Sat Nov 14 08:05:54 EST 1998 | Earl Moon
| | | | I believe that gold fingers on my circuit boards are being | | | | contaminated and need to clean them with some chemical | | | | solution. Any recommendations. | | | | | | | Chuck: What is the type and source of your contamination? Dave
Electronics Forum | Wed May 03 15:00:44 EDT 2006 | patrickbruneel
It all depends on process, design and environment in which the contacts are used. Both have excellent conductivity characteristics Both don't oxidize over time On the other hand gold is much softer then carbon, and after hitting that contact a gazil
Electronics Forum | Wed Sep 10 02:47:49 EDT 2003 | Dennis O'Donnelll
This is a problem of contamination in the plating bath. Most prominent with white tin and some gold over nickel plating processes. Rather than argue with your vendor over the issue, and to avoid future recurring problems, I use either HASL or elect
COT specializes in high quality SMT nozzles and consumables for pick and place machines. We provide special engineering design service of custom nozzles for those unique and odd components.
2481 Hilton Drive
Gainesville, GA USA
Phone: (770) 538-0411