Electronics Forum | Fri Mar 24 08:10:12 EST 2006 | mapell
Hi AR Nice job on the chain/rail cleaning. I would contact Speedline Electrovert tech support, 800.737.8110 to assist in trouble shooting. They can walk you through using a meter to measure input and output current to the SC card and make sure tha
Electronics Forum | Tue Jan 12 10:17:15 EST 2016 | swag
Battleship - very nice! I like that. It's about the size of one, too! (Probably weighs more, though). Thanks much for the info, I'll get ahold of Mike and see if I can get a little advice.
Electronics Forum | Mon Apr 24 14:04:44 EDT 2006 | pjc
You did not tell us where your boards fit on the thermal mass range. That is key. I've run Pb Free low to medium thermal mass boards with good results on a 5 zone oven (5 top/5 bottom). You should not have a problem running a medium thermal mass boa
Electronics Forum | Thu Feb 19 15:17:52 EST 1998 | Bipin Napal
Available immediately. Call Bipin at 416-385-0855 Make: Electrovert Model: 500 CLV Electrical: 440V, 3Phase, 60HZ Manufacturing Date: Dec 22, 1992, and upgraded in 1994 Physical Size: Length 205.5�, Width 55� Heating Zones : 10 Upper & 10 Lo
Electronics Forum | Wed Oct 07 10:04:07 EDT 2009 | soudomphong
Thank you for responding. I called Speedline tech > support he think there is a short some where in > the motor. I changed the motor out and still have > the same problem. The chain is normal, and using > automatic lubricating. I will check more
Electronics Forum | Tue Feb 27 10:26:19 EST 2001 | jcboetcher
Hi I'm a first time user of SMTnet. I have a Electrovert Wave Soldering Machine Ultra 2000 with a AT&T Spray Fluxer. I'm looking for a upgrade or a replacement Spray Gum Binks Model No. Z-6-434 and or nozzles ( Fluid tip assembly No. 184A / 156A.
Electronics Forum | Fri Feb 15 10:09:24 EST 2002 | PeteC
The Electrovert AquaJet w/ Closed-Loop runs like $63K to $107, depending on the AJ config. The AJ is like the only batch machine I've seen that is not a glorified dish washer. Justification depends on your application. The batch system takes less spa
Electronics Forum | Tue Aug 13 15:55:10 EDT 2002 | jseagle
I am looking for advice on purchasing a used '98-'00 Electrovert Electra wave soldering machine. Are there any specific parts of the machine I should closely inspect? Any specific options I should make sure it has? I will need it to have a spray f
Electronics Forum | Mon Mar 10 16:29:09 EST 2003 | julief2000
Kevin, The Technical Devices Machine, the EVS is a stand alone system that can reclaim up to 75% of the dross weight as usable solder. It has a much more proven history than the Electrovert add on, as well as being lower priced. The Technical Devi
Electronics Forum | Fri Jun 13 10:37:38 EDT 2003 | joeherz
I may have the oppurtunity to purchase this machine. My experience with in-line machines is limited to Trek (Triton IV) and Electrovert (aquastorm) having success and failure with both. The equipment would be used strictly for an OA chemistry and w