Electronics Forum | Fri Jun 03 09:37:59 EDT 2016 | sumote
Same here. Buy it by the 2-pack at Staples. If the tape does not get used often we pull off about 5 inches and discard before we use it. The exposed tape between the cutter and the roll, and 1 rotation around the outside of the roll attracts dust and
Electronics Forum | Wed Mar 06 15:49:50 EST 2019 | rhoderik
Hello, I have an MPM Accuflex at work that has suffered an accident. Some wires have benn pulled off a connector and now we don't have a clue about how it was connected. Can someone send the pdf manual to me? My e-mail is rhoderik@hotmail.com Thanks!
Electronics Forum | Thu Oct 16 15:19:11 EDT 2003 | Ernie
BAD COMPANY???? Or good Business? $14,000 fee for a machine not purchased from the OEM is for a Service Contract, not a licensing fee. For this, you get four 5 day service trips over a year and 20% parts purchased for used machines. Considering the
Electronics Forum | Tue Feb 21 09:19:50 EST 2006 | Chunks
Hi Mark, Not to be condescending, but is your 265 camera in focus? I've seen one instance of this. If it�s not the camera, and you are sure all your other parameters are good, , then poor definition can be from bad snap-off or bad gasketing. Snap
Electronics Forum | Mon Jun 25 19:36:36 EDT 2007 | bga_kid
If you calculate CFM using the numbers you have provided you are pulling 1396CFM out of the oven. I am not sure what Hellers spec is but I know a Speedline OmniExcel Air machine should be set at 300CFM. I do know for a fact that to much exhaust can s
Electronics Forum | Thu Jul 10 21:11:11 EDT 2014 | andrespena
@Alexei Shkolnik Ah, I hope this doesn't become a problem. But if it does perhaps we can redesign the whole system? Push the components with a pusher that's connected from above rather than pulled by a magnet below. Perhaps the pusher can still clim
Electronics Forum | Mon Nov 15 14:40:38 EST 1999 | Bob Smith
Hi, I have a problem I've never seen before so I hope someone here can help. A recent batch of PCBs arrived where the copper lands delaminate with a small pull. Normally you have to pull pretty hard and the whole land comes off the substrate. These
Electronics Forum | Mon Apr 01 10:09:03 EDT 2013 | markhoch
It sounds as if you have your AOI set up off-line, and you're "AOIing" a sampling of the PCBs produced. If that’s the case, then the responsibility of who drives the inspection really depends on how you configure it. If it's based on the number of P
Electronics Forum | Fri Aug 02 11:48:23 EDT 2002 | johnw
I can't think of any off hand other than the Ersa which is massive and from when I used it a pain in the A*SE to program and keep programmed, you always seem to have to baby sit it. I bet if you asked you could get one, the problem is that forced con
Electronics Forum | Mon Aug 29 13:01:57 EDT 2005 | stalkerb
PR thankyou for your feedback, your comments are extremely helpful. We have a customer product porfolio of about 900 active products, covering approx 700 different fabs. your comments are absolutely valid with regards to Speed, however in our scena