Electronics Forum | Tue Feb 21 09:31:20 EST 2006 | Chunks
It depends on many factors. What size is your board? How many placements? What mix of placement? If you are performing preset-ups, your line mix, multi-up panels or single boards, etc....
Electronics Forum | Sun May 07 19:29:52 EDT 2006 | Dhanish
I am seeing high solder bridging for Nexlev Connector.Can someone advise what are the factors causing Solder Brdiging for Nexlev issues.
Electronics Forum | Thu Jun 22 00:16:24 EDT 2006 | Gman
Hello, Has anyone had issues with voiding while using Imm Silver PCB finish. Does thickness of silver, contamination of the plating bath or other factors if you come point out cause voids due to the plating.
Electronics Forum | Fri Sep 22 04:44:55 EDT 2006 | basem
We choose i-PULSE as our#1. However, we have concerns in regards to maintainance, reliability, and accuracy. High density, small form factor, and high performance products. If you think the M4Es can do the job for us, then let us know. Thanks, Bas
Electronics Forum | Wed Oct 18 16:29:55 EDT 2006 | df
Hi all, If a component is rated as Peak Temperature 225 DegC. Is there a safety factor built into this rating or is it exact? df...
Electronics Forum | Thu Nov 30 09:28:23 EST 2006 | SWAG
Cycle time is one thing, "operating factor" is another. Set-up and tear-down should be seperate from cycle time as well.
Electronics Forum | Fri Dec 01 08:58:05 EST 2006 | russ
orientation is also a factor here, So what is the pitch of these connectors? the lead length? the hole dimensions? surface finish? and what type of wave and flux are you running? Shorts are pretty easy to eliminate if everything is of adequate des
Electronics Forum | Wed Dec 27 15:07:14 EST 2006 | realchunks
Hi Jack, I've seen around 7 degrees diff in max temp. The real factor here is time to reach peak and time at peak.
Electronics Forum | Wed May 02 06:56:52 EDT 2007 | Rob
Has anyone experienced deformed balls on BGAs - especially very low volume build to order devices? I'm looking into a possible hidden pillow defect and think I have eliminated most of the other factors I believe could cause it. Cheers, Rob.
Electronics Forum | Tue Mar 06 21:28:10 EST 2007 | fastek
No kidding...and if you can guarantee the prostitution rate would increase by a factor of 10% instead of 2%......more equipment brokers would attend.