Electronics Forum | Mon Oct 07 22:06:43 EDT 2013 | action_101
I successfully inspect solder on plcc's with angled cameras on the yestech we have. In the past I have successfully inspected for solder with angled cameras on mirtec machines for both plcc's and qfn's. Other than inspecting solder on those two types
Electronics Forum | Thu Feb 12 22:21:08 EST 2015 | shahrat
So what problems you are facing with Mirtec? Can u check coplanarity, less solder, polarity, dry solder,Pads not properly got the heat for 1005 package. Can u also check 0105 components that is surrounded by some tall components? what about false cal
Electronics Forum | Fri Feb 13 08:41:45 EST 2015 | emeto
Hi, I have MV-7xi from Mirtec. Mine is equipped with the best camera they have as well as telecentric lens which give you very good resolution and view. Machine handles very good most of the defects in SMT. However, when we go to the solder joints i
Electronics Forum | Thu Aug 18 09:41:05 EDT 2016 | jbuckley
Typically on my company's Mirtec systems, any anomalies, such as cracks, chips, etc. on chip capacitors and chip resistors are going to be detected with just a basic mounting inspector. We have a full image of the part (solder joint not included) as
Electronics Forum | Thu Apr 04 10:06:11 EDT 2019 | robl
Hi Vikram, Have you looked at the rotating flux buster style pins? A few people do them, but this is probably the best illustration: https://ingun.com/en/Products/ProductGroups/ICT_FCT/CategoryFolder/RotatingTestProbes We also find that the longer
Electronics Forum | Tue Apr 27 11:13:14 EDT 2021 | dontfeedphils
I've really liked Koh Young in the past, but it's been a few years. I really disliked a lot of aspects of the Parmi system (lots of false calls and lower quality hardware IMO). The last time I was looking for 3D AOI I liked what I saw of the SQ3000
Electronics Forum | Fri Feb 11 19:07:16 EST 2005 | primus
We are also looking for AOI machines, pre- and post-reflow. We already tried one machine from the UK (I don't remember the name, I perfer to forget we ever had it) and they told is it would do everything we wanted. Maybe so, but not well enough. It s
Electronics Forum | Mon Nov 22 11:16:04 EST 1999 | Boca
Chris, Some ramblings- Your choice depends on factors like which defects you're looking for, bugdet, quality inspection philosophy, high or low mix environment, sample sizes or 100%, and so on. Are you going to test 100% of the product coming off t
Electronics Forum | Tue Feb 17 09:33:43 EST 2015 | emeto
Hello, I have two of these for the last 3 years(MV-7xi). Buy the machine with the best camera they offer and with the telecentric lens - it gives great view and resolution. I had to replace the controller for conveyer open/close on both of them. I a
Electronics Forum | Sat Feb 12 13:40:27 EST 2005 | etienne
As I was explaining in my thread, the things that you have to look for when buying an AOI is the false calls rate (which you described perfectly) vis a vis the money and time you want to spend. We bought our machine after that we evaluated some. As y