Electronics Forum | Sat Sep 23 15:13:40 EDT 2000 | Francois Racine
Hi Sophia, I`m responsible of SMT line and we solved this problem with a complete automatic solder paste printer machine. In the past we had problem with off alignment and solder height too.... at that time we used a semi-auto printer machine and w
Electronics Forum | Sun Jul 08 23:05:57 EDT 2001 | Darby
John, Tenryu/Amistar/i-Pulse made stainless replicas of feeder tape for various pitches and feeder widths. Part # for 0402 is "MT-0802" ( 8mm wide x 2mm pitch ). Standard 8mm wide tape is " MT-0804". If you can't get any of these, spend an hour on yo
Electronics Forum | Mon Aug 21 09:19:35 EDT 2006 | lfaustini
Hello, I recently purchased a used (obviously!) Siemens ms72a pick and place machine. This is an old unit, that was "run" by an old HP9000 computer, over IEEE488 bus. Also, the machine came with no (zero!) documentation ! (not one book!) Hav
Electronics Forum | Sat Nov 26 00:02:17 EST 2011 | kevintough
I agree with this post about new and standard component names. Standard components should not be changed outside of perhaps widening the tolerance to accept poorly produced components. By purchasing poor quality/cheep components your purchasing depar
Electronics Forum | Thu Aug 08 11:58:25 EDT 2013 | rway
I am not that familiar with the older systems. The software should be supported on both old and new alike unless you are limited by the operating system, but the camera will obviously have a lower resolution and perhaps the filtering is not quite as
Electronics Forum | Fri Jul 07 15:18:45 EDT 2017 | emeto
Tony, I will throw some thoughts here: 1. When we speak about shrink/stretch i start thinking about temperature right away. How do you store PCBs and or Stencils? Is your stencil getting hot or cold in the stencil printer? Are the boards on a room
Electronics Forum | Mon Aug 25 11:43:30 EDT 2014 | fuji_user_2014
Looking for information on how to stop our Fuji from picking up parts in advance for the next board at the in carrier. In other words, how can we stop the machine from picking up parts before reading fiducials on a board without adding a skip mark t
Electronics Forum | Mon Nov 26 14:13:55 EST 2007 | wayne123
I am not completely sure why it would tell you "board will not be populated" and then build it anyway, but if the only difference between the two programs (working one, not working one) is the fiducials are smaller, did you try reducing the search ar
Electronics Forum | Tue Mar 09 14:29:40 EST 1999 | Jason Hall
When a board has loaded into the machine and the fiducials do not line up I have tried to use mark edit to set an offset into the program. I lined up the crosshairs and set the data. For some reason the machine did not accept this info. Does anyone h
Electronics Forum | Thu Jul 23 13:28:55 EDT 2009 | pnguyvu
Hi PPM! Have your stencil house mark fid with laser machine - that how we use to have fid mark once it marked with laser it last very long time like stencil's life. Good luck! Steve USA STENCILS INC