Electronics Forum | Tue May 19 09:13:45 EDT 2009 | cyber_wolf
The loaders/carriers work well on CP643's in my opinion. We have had ours for about 4 years. However, if you crash them it can be a beeoch to get everything back into proper function. We have very little issue as long as we have our techs do rail wi
Electronics Forum | Mon May 12 15:08:11 EDT 2003 | stefwitt
1. Not quite. The width of 16 mm came most likely from the reel width, which can be up to 15 mm wide for the 8 mm tape. The reel for the 12 mm tape is up to 18 mm wide and would occupy already two slots. If you design a machine from scratch, I would
Electronics Forum | Tue Sep 07 06:49:18 EDT 1999 | stefano bolleri
| | | I agree SB..Fuji feeders rarely get off that much.Are you using | the Auto-Offset function in your Part data?This will | usually keep your pick on Cp's humming! | YES, always use the auto-offset function in each part data (do you also need t
Electronics Forum | Tue Dec 05 14:51:00 EST 2000 | JAX
Nick, In siemens terms: Fuji has the ability to check "ink spot" which I assume is what you are doing now. The only difference is the vision capabilities between the two machines. You do not have the freedom of siemens type gray scale with Fuji. Yo
Electronics Forum | Tue Dec 05 14:56:16 EST 2000 | JAX
Nick, In siemens terms: Fuji has the ability to check "ink spot" which I assume is what you are doing now. The only difference is the vision capabilities between the two machines. You do not have the freedom of siemens type gray scale with Fuji. Yo
Electronics Forum | Tue Sep 21 11:22:20 EDT 2004 | rlackey
Hi Arvydas, Do you want a machine specified at 20K per hour or to run at 20K per hour? Regarding Chipshooters I've worked with Siemens, Philips FCM's, Fuji's, Panasonics & Sanyo/Universal and the best in terms of reliabilty by a long way were the J
Electronics Forum | Fri Oct 26 08:40:26 EDT 2007 | mulder0990
Doing the research on the feeder jigs, I have found that certian jigs are not used in most places. I am hoping that some people with the different jigs can post their feedback on the jigs they have. I have been told that some of the 'cheaper' manuf
Electronics Forum | Tue Jan 01 22:50:53 EST 2008 | fastek
To get beyond the 36,000 cph threshhold the turret manufacturers had to focus on ways to get the boards in and out of the machine faster. This also included loading more boards inside the worknest. The end result in Fuji's case (CP-643), was a table
Electronics Forum | Fri Feb 25 05:12:12 EST 2000 | Dean
...problem? Are you not sure its not a "feature". LOL I have had the same problem...spent many hours tracing down the sequence of events which leeds up to this situation. No real solution...however, I use the key command zero set feature rather t
Electronics Forum | Fri Feb 25 05:12:12 EST 2000 | Dean
...problem? Are you not sure its not a "feature". LOL I have had the same problem...spent many hours tracing down the sequence of events which leeds up to this situation. No real solution...however, I use the key command zero set feature rather t