Electronics Forum | Thu Mar 04 22:37:58 EST 1999 | Larry Johnson
Does anyone out there have any information on this new "Fuji Motor Feeder" Price and how it compares to Hover-Davis. I should specify feeders for an Fuji IP-3. Any information would be great. Thanks Larry
Electronics Forum | Mon Mar 08 11:54:38 EST 1999 | Bob Schuster
| Does anyone out there have any information on this new "Fuji Motor Feeder" Price and how it compares to Hover-Davis. I should specify feeders for an Fuji IP-3. Any information would be great. Thanks Larry |
Electronics Forum | Fri Dec 15 12:08:26 EST 2000 | Alex B.
i'm going to try placeing 0402 with a fuji IP2. Will i have any problems and are there any sugestions thanks in advance Alex B
Electronics Forum | Wed May 17 03:00:45 EDT 2000 | Avichai Ramot
I have shifts in the placement of qfp240 components. I have this problem with al my IC machines: Fuji-Ip2,Ip3 ,siemens F-4.
Electronics Forum | Fri Jan 09 00:30:38 EST 1998 | S. S. Bist
| Machine has less than 5000 hours. VERY clean machine, comes with controller and 80 feeders. Available now. Please tell us, the offered price for IP-2. We have a potential buyer for this machine. Thanks and Regards S. S. Bist
Electronics Forum | Tue Apr 23 19:14:26 EDT 2002 | mantis
What is the error your getting,I have used the ip3 to place Bga'a before and had no difficulty i was also using the MCS30.
Electronics Forum | Wed Apr 24 11:02:01 EDT 2002 | cnoonan
This may not be the answer you were looking for, but I have worked for serveral leading technology companies and we used vision (type 10)on IP3, and QP3 machine and never had a problem with placement issues.
Electronics Forum | Fri Mar 05 00:53:09 EST 2004 | alwil
I have an Electrolytic capacitor which is 17mm in diameter and is 16.7mm in height. It is presented in a reel,44mm x 24mm. I want to know if there is a suitable feeder available to place this part onto a Fuji IP3. Thanks, Alan.
Electronics Forum | Fri Sep 16 08:36:45 EDT 2005 | ajay
check some relay might be bad on MTU. we faced similar problem in IP3.
Electronics Forum | Wed Dec 20 07:08:51 EST 2006 | cyber_wolf
We have had this happen. The Z-ball screws do go bad in IP3's. We replaced the ball screw and the problem went away. As mentioned improper belt tension will cause the servo to make loud noises. But if you say the movement is rough, then the ball scr
