Electronics Forum | Mon May 14 11:41:22 EDT 2012 | kmakiya
It's been a really long time since I worked on a GSM but we did have some spindle problems and it was the clutch that was not working properly. The head was removed from the machine and a special tool was needed to remove the clutch. A caibration was
Electronics Forum | Thu Oct 25 19:53:42 EDT 2012 | sonavc
Thank It worked without the user name and password.When I try to zero axis I have other error unable write to global memory 5008. My machine, when turn it on i don't see the power to the Digiplan 8 axis modular and no bright on 24VAC on at servo co
Electronics Forum | Thu Oct 02 15:17:22 EDT 2014 | arifa_anees
you can find it on different sites, for refernce some are given below: www.keller-druck.com/picts/pdf/engl/man_gsm2_e.pdfCachedSimilar https://www.sparkfun.com/.../CEL-09533-User's%20Manual.pdf www.cybrotech.co.uk/.../Manual/GSM-SA%20User%20Manual
Electronics Forum | Fri Oct 03 10:52:32 EDT 2014 | rgduval
Thanks for the suggestion, Arifa. However, it doesn't look like any of these are for the Universal Instruments GSM2 pick and place machine. The Keller-Druck link is for a GPRS Modem with a datalogger. The Sparkfun and Cybrotech sites seem to be
Electronics Forum | Tue Oct 14 09:21:38 EDT 2014 | rgduval
Thanks, Tushar, we might give that a try. The only reason I'd lean away from it is because I've been able to determine that I can't get the nozzles to move down on head 2 in the manual screen (or move the theta). I may be chasing two problems, but,
Electronics Forum | Tue Oct 14 14:08:22 EDT 2014 | dilogic
No, each card in LP servo rack drives only one motor. But there is an servo cotnroller board (actually 3 of them) in the VME rack (where all computers are). Third one from the left(slot13) controls head2 theta and z axis. That might be a cause of you
Electronics Forum | Thu Jun 02 15:16:54 EDT 2016 | dilogic
I did try to null the axis - no improvement. I have AMC software and tried (almost) everything related to electronics (except for changing linear encoders, but this seems to be OK - when I move axis manually, position numbers change smoothly). It loo
Electronics Forum | Fri Apr 28 02:10:19 EDT 2017 | bukas
i'd say its a ball nut. maybe it came loose or the balls are worn out. also, check timing belt! if resonance is periodical like you say then there is great probability that belt or/and belt pulleys got worn out. i had combination of these on one of m
Electronics Forum | Fri Dec 09 11:21:52 EST 2016 | ilavu
I have one GSM2 with Flexjet on both beam. I want to replace one beam with Flex head to get more flexibility. My machine is equip with ULC in both front and rear. Also, it is OS/2 with 4.5 software. I do have one working Flex head that can be use. I
Electronics Forum | Tue Jan 16 15:13:51 EST 2018 | ilavu
Hello All, I am in need for "Platform Set-up Validation" (PSV) for my Universal GSM2 with UPS version 4.5. My installation disk for PSV is bad and can not reinstall after hard drive crash.My machine is not register with Universal because some serial
