Electronics Forum | Sun Oct 10 17:40:50 EDT 1999 | JohnW
| | | Is there an IPC Standard stating the max. number of times that a PCB can pass through a reflow or wavesolder machine without having solder mask breakdown. | | | | | | PCB is FR4 | | | Solder Mask is LPI | | | Reflow and W/S Profile = Standard
Electronics Forum | Wed Jul 14 11:36:56 EDT 1999 | Jimmy Strain
| | | Hi All, | | | Does any one experienced the solder on gold finger after | | | reflow. Its about 5 to 8 mils diameter . | | | We'd clean the entire screen printer, mounter & reflow as well, | | | but doesn't help much. | | | | | | | | Mr Kong..
Electronics Forum | Mon Dec 13 19:34:09 EST 1999 | Steve Thomas
Thanks, gentlemen. All points well taken, and some hit pretty close to home. Our pick-and-place programmer assures me that coplanarity isn't the issue because the machine won't (or can't) place parts beyond an acceptable criteria. It's an Amistar
Electronics Forum | Thu Jun 25 14:45:55 EDT 1998 | Chrys
| I have a single-sided board with test vias that pass through the board. The test vias are pasted and reflowed with the SMT components on the top side. When the boards are wavesoldered, the solder coverage on the vias is spotty. Some will sold
Electronics Forum | Fri Jun 27 10:27:59 EDT 2003 | davef
Since you�re asking the question about proper handling of OSP board, there may still be time to talk you out of using that material. * Cleaning of mis-printed board could cause non-wetting problems. This tends to remove a fraction of OSP coating. 0.3
Electronics Forum | Tue Oct 12 16:08:44 EDT 1999 | Brian
| I need your help! We have been doing double sided surface mount for 4 years now. Up until 6 months ago I have not had a tombstoning problem. Since then I have a fairly high incidence rate of tombstones on the 0603 size resistors (no other parts).
Electronics Forum | Fri Apr 02 02:01:24 EST 1999 | P.L. Sorenson - Technical Consultant
| | | Has anyone heard of a problem with catastrophic failure of | | | large value (200uF) solid tantulum capacitors that have been | | | exsposed to high humdity. | | | | | I suppose that with water moisture seep in the capacitor, the risk is ver
Electronics Forum | Tue Dec 29 17:42:27 EST 1998 | Dave F
| Can anyone recommend a solder stop that can be applied by our PCB supplier. Our current material form Tamura Kaken is causing problems. | | The material should be capable of withstanding 1 Surface mount IR reflow cycle and 1 wave solder cycle. | W
Electronics Forum | Sun Dec 10 11:55:16 EST 2000 | Bob Willis
The following may be of interest to you. INTRODUCTION TO X-RAY INSPECTION All text Copyright Bob Willis, EPS INTRODUCTION TO X-RAY INSPECTION The use of X-ray inspection is becoming very popular due to the increased use of Ball Grid Array (BGA)
Electronics Forum | Sun Dec 10 11:55:28 EST 2000 | Bob Willis
The following may be of interest to you. INTRODUCTION TO X-RAY INSPECTION All text Copyright Bob Willis, EPS INTRODUCTION TO X-RAY INSPECTION The use of X-ray inspection is becoming very popular due to the increased use of Ball Grid Array (BGA)
