Electronics Forum | Tue Oct 13 22:56:22 EDT 2009 | cpcompany
Can anyone help me recommend or simulate a SPI > and AOI machine that can balance our FUJI NXT 1 > with 14 modules. We are using MPM accela printer. > 200 UPH is our target. > > Here's the PCB > dimension > > length(x) = 399.92mm width(y) = >
Electronics Forum | Wed Sep 22 01:35:27 EDT 2021 | david0811
hi, i looking for MPM125 manual operation and also datasheet. please assist
Electronics Forum | Mon Feb 12 12:51:19 EST 2018 | dleeper
Yes, the vision system in the MPM accuflex, as well as on other MPM printers is reversed. It's kind of weird but you get used to it.
Electronics Forum | Mon Apr 28 21:51:56 EDT 2014 | elabcircuits
Hello, We have a MPM UP2000 HiE printer from 2000, software version 7.2E. The PC board is not booting anymore (black screen), no drives spinning. It's an Advantech 486SX version. Question: would a Pentium 3 SBC (Single Board Computer) with ISA
Electronics Forum | Thu Mar 30 07:44:19 EST 2006 | Chunks
UP 2000 is a good printer. Spares are normal - blades, stencil/board light bulbs, the over head flourecent, get new conveyor belts. Take the cover off the tactile sensor and make sure it's clean also. Other than that it should be a work horse.
Electronics Forum | Mon Aug 28 12:07:15 EDT 2006 | cyber_wolf
We are looking into purchasing a used UP-2000 Hi-e. We are high mix /high change-over. The machines I am looking at are equipped with the grid-lok system. Can anyone give me pros's/ con's ?? Thanks in advance. Sr.
Electronics Forum | Sat Sep 02 07:38:43 EDT 2006 | cyber_wolf
We have decided to go with a UP2000 Hi-e with the newer generation Grid lok. This is a refurbed machine with a warranty.
Electronics Forum | Thu Apr 01 14:34:58 EDT 2010 | jgalarza
I had a Cognex card go out on me today. Does anybody know which Cognex card versions I can use with my UP2000 software version 6.3D?
Electronics Forum | Thu Feb 19 12:29:19 EST 2015 | tnisbet
We stock most sizes of Squeegee blades as well as most replacement parts for the UP 2000. We have service technicians for feild service & phone support. many of our parts are listed on our website: http://www.ppmparts.com Tom NIsbet PPM
Electronics Forum | Fri Feb 19 11:17:29 EST 2010 | kpm135
When I try to load a board in our MPM UP2000 HiE I get the following error "Z axis software limit". The Z axis will move up and down freely, I re-calibrated it and reprogrammed the board and the error continues. Has anyone else run into this issue an