Electronics Forum | Fri Sep 22 09:06:33 EDT 2006 | daxman
We've got a problem with our AP25.. I just finished repairing and calibrating this printer. We needed to replace the camera. After the cal. was done, the print accuracy was superb. However, it seems now, the consistency will not maintain itself. T
Electronics Forum | Mon Mar 03 13:08:53 EST 2008 | rrpowers
I have a couple old AP25 printers (circa 1994) that I inherited with an SMT process. I don't have a lot of details about the various parameter settings within the setup menus. I have the User manuals, but they only give very basic information. I i
Electronics Forum | Tue Aug 31 20:06:12 EDT 2004 | adiaz
Hello All, We have our MPM AP25, S/N: 6791 down due to problems with the following cards: - P1280 - Digital Motion Controller - PC101 - Motion Interface Board These boards are obsolete and are not in stock, we would like to know if you may have th
Electronics Forum | Mon Oct 31 03:42:47 EST 2005 | pavel_murtishev
Good day, Problem appears only with 0.5mm pitch components. Print quality for these components is unacceptable. Paste type isn�t new for us. No any tape on the bottom of the stencil. We apply enough pressure on squeegees, stencil remains clear after
Electronics Forum | Mon Oct 31 14:46:54 EST 2005 | valuems
Hello Did you just buy this machine on the used market? There is a possibility that the stencil is not height on all 4 corners ( from the center nest assembly. I don't under stand " the under stencil wiper is not working correctly". This is about
Electronics Forum | Tue Mar 06 08:33:40 EST 2007 | cardinal
You can get a topside edge-clamping system to fit your AP HI E printer from Gridlok. They make a universal tooling system and topside edgeclamping system for the AP series and UP 2000 series printers. The Y snugger tooling option when ordered with t
Electronics Forum | Fri Sep 21 16:57:47 EDT 2007 | chrisgriffin
Harry is right. Too much moisture in the air lines screws up the air cards. These pro-heads are somewhat of a pain to calibrate. I think it is a little pre-mature to say you probably need pneumatic cards. You just need to calibrate the pro-head.
Electronics Forum | Fri Aug 03 16:46:59 EDT 2001 | davef
It's OK to have a thin film or haze of paste left on the stencil. Printing nice bricks of paste is the important thing. Assuming you know these things, so tell us more about your situation. PRINT QUALITY: What do your paste deposits look like?
Electronics Forum | Tue Jun 01 05:17:16 EDT 2004 | Alistair MacAdam
I am currently looking at the volume of paste being deposited on a PWB 2.4mm thick with a 0.25mm tolerance. I am looking for information on PWB variation and a MPM AP25 series printer, and can the volume of paste be controlled on varing PWB thickness
Electronics Forum | Tue Jul 27 19:37:51 EDT 2004 | simmcircuits
Thank you Paul, this is the actual information I need to adjust the camera! At the moment I have actually reduced the offset values down to 0.7 from a previous 4.0. I have done this by editing the AP.CAL, took a while to get the proper values as I ha
.gif)
