Electronics Forum | Tue Jul 14 13:45:04 EDT 2009 | christian01976
Hello! You could check your pick an mount vacuum, too. You can do it in COMPONENT INFO with the ADJUST ASSISTANT (F6). Then PICK UP COMPONENT. If you don´t know how to read the grafic that is shown then just push F1 for HELP. What size do the TANT h
Electronics Forum | Thu Aug 31 14:15:34 EDT 2023 | compit
Hello What feeder do you use for the long connector (65-80mm) - tape feeder, tray? What nozzles? We want to mount a SODIMM200 socket. I don't know whether to look on the tape or on the trays... The MG1 spec says it will mount connectors up to 100mm (
Electronics Forum | Fri Sep 01 11:55:27 EDT 2023 | tommy_magyar
In my previous job we fitted these connectors with bespoke gripper nozzles (ASM/Siplace) from bespoke trays made for these due to the high volume. It also reduces the risk of damaging the component further in case of a reject. However, at my current
Electronics Forum | Mon Oct 09 13:36:30 EDT 2006 | ppminc
Phil, The QSA-30 was built by Sam Sung, Sold by Quad. Single Head 2 Nozzles around 11K CPH Quad does not support the machine but I believe you can get parts direct from Sam Sung. I am not sure if they have a registration fee. The QSA used Quad made
Electronics Forum | Wed May 21 15:47:34 EDT 2003 | JB
We have an HSP 4796, if the feeder mechanism is the same, this may help you a bit. First make sure that the componet definition is right on the component library. Tape or Embossed. Second, the component thickness vs actual thickness. Is the pick u
Electronics Forum | Thu Sep 03 22:03:32 EDT 2020 | SMTA-64386139
Both conditions are acceptable for this bottom brazed flat pack package. The solder coverage must be within 0.070 inch of the lead/package interface per MIL-PRF-38535, paragraph A3.5.6.3.4.a. While that requirement could allow for a gold gap near t
Electronics Forum | Wed Nov 29 01:09:17 EST 2006 | Guess
I would suggest checking the feeder, MVF and MSR are both turret type and dont have the capability auto pik adjust in y. Y offset pick up would lead to : 1. Over turn component. 2. Missing component. Turret sequence is pick, recognize an
Electronics Forum | Fri Jan 22 15:48:14 EST 1999 | Chrys
| Hello, | | I will be evaluating and qualifying two equipment types. The first is a fountain soldering device. I need practical advice on all the stuff you guys and gals know about as good, bad, ugly, best applications, setup, limitations, and all
Electronics Forum | Mon Oct 24 01:19:10 EDT 2005 | darby
Hi Mike, I use variations of both of these machines in a Tenryu FV-7100s and Samsung CP45/CP45Neos. Both have been very good machines - I would find it difficult to split them. I have personal dislikes of both tooling and support systems. I would ta
Electronics Forum | Sat Jul 17 15:22:17 EDT 2004 | rohman23
Thanks for all the responses. I do agree with what was said, and can certainly see reasons not to try. I'll write a little more about what we do. We are a defense contractor, and as I mentioned very high mix, low volume. We only have 1 SMT line.