Axial Glass NTC Thermistor Temperature Sensor is transition metal oxide material made semiconductor ceramic NTC Thermistor chip hermetically sealed in DO35 glass shell, with axial tinned Dumet wire, for temperature sensing measurement detection, indi
1/10 Watt, 0805 chip package, +/-5% tolerance, resistance ranges from 10 Ohm to 1Meg Ohm
Our Anti-Static Runner quickly drains static electricity from standing worker. *Surface to ground: 107 ohm *Surface to surface: 107 ohm *1/8" Smooth non-skid surface *Extremely durable. Great for high traffic areas *Available in widths of 3' and
Gold finger PCB/Impedance computer circuit board Layer:6 Thiness: 2.0mm Surface treatment: ENIG+Hard gold plated on gold finger Impdance control: Single-ended 50ohm, differential 90 ohm Application: Computer
Welcome to the next generation in PWB test solutions. We combine an exceptional team of technology and applications experts with HIOKI's industry-leading systems to enhance your reliability and to speed up your product development process.
Industry Directory | Distributor / Manufacturer
I am Mr. Nirmal Patel working with M/S Elektronika Sales Pvt Ltd,Vadodara. We are in to Electronics Component & Electro Mechanical components distribution.http://www.elektronikasales.com/linecard.php
Used SMT Equipment | General Purpose Test & Measurement
Specifications: Number of Channels - 2 AMPLITUDE RANGE - MAX 1.25Vp-p into 50ohm AMPLITUDE RANGE - MIN .03Vp-p into 50ohm STANDARD MEMORY/RECORD LENGTH
Technical Library | 2023-06-02 14:13:02.0
This work examines the use of dual-material fused filament fabrication for 3D printing electronic componentsand circuits with conductive thermoplastic filaments. The resistivity of traces printed fromconductive thermoplastic filaments made with carbon-black, graphene, and copper as conductive fillerswas found to be 12, 0.78, and 0.014 ohm cm, respectively, enabling the creation of resistors with valuesspanning 3 orders of magnitude. The carbon black and graphene filaments were brittle and fracturedeasily, but the copper-based filament could be bent at least 500 times with little change in its resistance.Impedance measurements made on the thermoplastic filaments demonstrate that the copper-based filamenthad an impedance similar to a copper PCB trace at frequencies greater than 1 MHz. Dual material3D printing was used to fabricate a variety of inductors and capacitors with properties that could bepredictably tuned by modifying either the geometry of the components, or the materials used to fabricatethe components. These resistors, capacitors, and inductors were combined to create a fully 3Dprinted high-pass filter with properties comparable to its conventional counterparts. The relatively lowimpedance of the copper-based filament enabled its use for 3D printing of a receiver coil for wirelesspower transfer. We also demonstrate the ability to embed and connect surface mounted components in3D printed objects with a low-cost ($1000 in parts), open source dual-material 3D printer. This work thusdemonstrates the potential for FFF 3D printing to create complex, three-dimensional circuits composedof either embedded or fully-printed electronic components.
Industry News | 2014-07-16 11:29:31.0
Pickering Interfaces, a leading provider of modular signal switching and instrumentation for use in electronic test and simulation, is expanding its range of PCI precision programmable resistor solutions with the introduction of two new PCI cards.
Industry News | 2014-07-16 15:45:12.0
Pickering Interfaces is expanding its range of PCI precision programmable resistor solutions with the introduction of two new PCI cards.
