Electronics Forum | Thu Jun 02 10:28:34 EDT 2016 | mnorthey
I have a number of machines sitting in the back room that I have been trying to sell. 8 Siemens (4 S15's and 4 F3's). A good start if you are interested; I also have an older Omniflo7 Oven as well as an old printer if your interested. All are older b
Electronics Forum | Thu Feb 02 12:39:41 EST 2017 | mnorthey
We have been using Vitronics for over 20 years with very few problems. I imagine Heller is just as good, I would rather you talk to your Solder provider Rep to find out about any add-ons you need for your specific processes. Along with that info and
Electronics Forum | Mon Apr 29 00:29:11 EDT 2013 | aemery
If you have a UPS on your machine there should be auxiliary contacts in the main breaker switch SW 1. These contacts tell the UPS if the main rotatary switch in turned to on or off. If the rotary switch was set to off the UPS knows not to turn on i
Electronics Forum | Wed Sep 02 11:52:40 EDT 1998 | Dick Casagrande
We are investigating equipment for a new SMT line. We are an OEM doing thru hole assembly and now must decide whether to do SM assembly in house or sub-contract out. We are a low volume/high board mix company. Our boards are mixed tech with SM on bot
Electronics Forum | Sun Sep 06 12:46:22 EDT 1998 | Phillip Hunter
| We are investigating equipment for a new SMT line. We are an OEM doing thru hole assembly and now must decide whether to do SM assembly in house or sub-contract out. We are a low volume/high board mix company. | Our boards are mixed tech with SM on
Electronics Forum | Mon Nov 17 18:40:10 EST 2003 | Ray Wilson
Advanced electronic assembly convection reflow ovens include a variety of options for cooling product after reflow. The Electrovert Omniflo series ovens include options for internal or external cooling systems. What are the pros and cons of utilizin
Electronics Forum | Thu Apr 15 01:29:35 EDT 2004 | pyro747
Hello Everyone, I am having a pin chain speed problem. The speed of the chain will slow down after start up of the oven. Example if you set the conveyer to run at 41 in/min, as the oven warms up of conveyer will slow down phycally but won't chan
Electronics Forum | Fri Apr 16 10:34:29 EDT 2004 | kauer
A couple of questions for You. How old is this oven? Does it have a history of problems? When I have seen speed variations with our Omniflow 7s it is usualy the encoder but it usually spikes rather hard in one spot. You can see this physically and by
Electronics Forum | Mon Mar 20 09:08:42 EST 2006 | mapell
AR Sounds like dirty chains... couple ways to check... Pull off the drive chain for the conveyor. Place a wrench on the (unload end) drive shaft and spin, if it is a bit tough.. dirty rails. Also look at load end of chains. The chain goes low and w
Electronics Forum | Fri Feb 15 15:55:58 EST 2008 | pjc
This is from the OmniFlo 5 Engineering data sheet: EXHAUST SPECIFICATIONS: STANDARD AIR OPERATION: - Load-end: 150 cfm (255 m3/hr) at the 4� (102 mm) stack (minimum requirement) - Unload-end: 300 cfm (510 m3/hr) at the 4� (102 mm) stack (minimum req
