Electronics Forum | Wed Nov 16 11:30:20 EST 2005 | nkbkiran
If PCB board size is my constraint ....and I have designed my circuit ... 1. How to optimize the layout of design for smaller space? 2. How to run simulations if any to do intelligent SI test? Does packages by Cadence, Mentor support this kind of o
Electronics Forum | Fri Apr 21 23:28:54 EDT 2006 | SD
Sounds like you have a non-IQ system? If you can, get one! It makes life much easier. Costly, though! Anyway, as stated above, your best bet is to assign multiple boards to the same table top. If the two boards are 99% similar, use a full opti
Electronics Forum | Mon Jul 24 10:00:08 EDT 2006 | SWAG
I think I read a thread very similar the other day but can't find it. If I remember correctly, the component database for that part was polarized and pre-orientation was used for camera inspection. It turned out that the optimization module in the
Electronics Forum | Thu May 15 05:24:55 EDT 2008 | grahem
Hi guys, Yesterday when I was with my friends I heard that some of my friends were speaking about Optimizer and board wave soldering. At that time I didn�t get anything about it however can somebody help me out that how does an Optimizer related with
Electronics Forum | Fri Nov 06 21:23:46 EST 2009 | vinitverma
Hi Mike, Yes you're right! That's why I normally ask for multiple sample files so as get as much information as possible. Your remark about the optimization software is correct. THE product that we are developing will NOT optimize/auto sequence the
Electronics Forum | Mon Nov 17 07:15:36 EST 2014 | garym4569
If you have feeders that you want to always stay on the same machine/position, enter them in the permanent data for the machine in the MSL setup. That is a simple way to reserve locations. Also, the optimization can use any common parts set in perm
Electronics Forum | Fri Apr 11 16:14:41 EDT 2014 | superlen
I just noticed that under the print utility you can in fact Print To File, (disregard my earlier note about needing .pdf print driver) so this would give you an ascii ouput of the optimized feeder list. However, you still have to do it at the machine
Electronics Forum | Fri Jun 28 21:09:56 EDT 2019 | joseangulo
Hi everyone, So basically i have a Wave optimizer (Model: SW-op) And after it finish to take the information from the wave, It show L Contact Lenght 0.00 CM and R Contact lenght 0.00 CM Any idea what can i do to solve this problem? Thanks
Electronics Forum | Fri May 22 06:35:36 EDT 2020 | joost
No i dont have a manual for a Assembleon Emerald, if anyone can find one that would be a big help! also when i open the Optimizer there are very limited things i can do with it, i can tell it to have feeders in set position and tell it where to prio
Electronics Forum | Thu Jun 24 08:05:21 EDT 2021 | vinitverma
That's the correct way when optimizing a new program or with less part numbers. But when reoptimizing a running program, it may not be so convenient to change all feeder numbers to '0'. Here is where changing the position to 'Relative' helps without