Electronics Forum | Mon Nov 16 01:35:15 EST 2009 | chandika
for reject rate depends on various parameters, Part data parameters, (Body tolerance,Part pickup & transport speed etc. ) Also depend on vaccum level, ( During the PM we need to messure pickup nozzle vaccumlevel using manometer ) According to raw mat
Electronics Forum | Wed Jun 22 01:57:28 EDT 2016 | sachinverma
we face the problem to last month dry solder issue.when we found PCB is dry. (PTH not fill not properly)then we change the parameter like flux Tank pressure increase 130 to 250. after these activity PCB is ok no dry solder found......but problem is o
Electronics Forum | Wed Jul 26 17:32:39 EDT 2017 | circustactics
Anyone familiar with the K&S 4524A Wire Bonder? I'm trying to troubleshoot an issue: It fails to save or load programs. The tool will startup with the default parameters in program 1. The parameters can be changed but attempting to save to another pr
Electronics Forum | Fri Oct 18 15:58:42 EDT 2019 | tech1
3 different A12 tools and the same error could be a problem with the tool holder or a parameter. I suppose the locking tabs in the holder could be worn or bent and you could try removing one of the pins from the tool and setting it in a different loc
Electronics Forum | Tue Oct 20 20:23:48 EDT 2020 | stephendo
I think temperature is the most under appreciated parameter. I'm not saying that it is the most important parameter, Just that a lot people do not give it the consideration it needs. I don't think it mattered as much in the old days of saponifiers an
Electronics Forum | Fri Aug 06 17:19:46 EDT 2021 | SMTA-64387687
It seems to me that something is out of calibration. I noticed that you were reinstalling TPSys. Did this start after the reinstall? Did you restore a backup of your parameters, or recalibrate the machine with new values? Try changing the tools to "n
Electronics Forum | Fri Sep 06 11:58:21 EDT 2002 | Brian W.
The most effective method is to monitor both printing results and parameters. Periodically (maybe once per month), run QCCalc or another program to measure the machine's capability to hold its set parameters. I also run control charts on the paste h
Electronics Forum | Fri Jul 15 13:28:55 EDT 2005 | Brian
A process consists of much more than just thee machine. When developing a cause and effect diagram ffor the process, there are many parameters that fall outside the machine itself. There are Man, Machine, Methods, and Materials. Just monitoring th
Electronics Forum | Mon Jun 27 08:18:47 EDT 2022 | kelvinchoong
Hi All, Appreciate any inputs that may be given. Currently i am operating VP6000 Vapour Phase Reflow Oven from ASSCON. Over the last 2 years, we have around 100 different Recipes for many different PCBs. Each recipe is adjusted(6 Different Paramete
Electronics Forum | Thu Apr 05 22:24:32 EDT 2001 | davef
I think your solder mask is a partial cause of your solder balling. Additionally, adjusting some machine set-up parameters may also help. 1 If we were talking about a single assembly problem, we�d be thinking about the laminate, but since you say t