Electronics Forum | Mon Nov 09 06:28:03 EST 2015 | recard
Hi guys, we have a problem and I hope something can give nme some new information. We have big solderability problems with a gold plated board. We changed the paste already, but there is no improvement. Could the Vapor phase Technology cause the p
Electronics Forum | Thu Jul 14 14:57:54 EDT 2005 | pr
I would put the tactile sensor back in the Vacuum nest so operators won't drop it in the paste. my biggest wish, pr
Electronics Forum | Tue Oct 03 17:11:42 EDT 2006 | cuculi54986@yahoo.com
Our board suppliers tell us, there is no specification they use for HASL thickness, other than "coverage". They also say they have very little control over the HASL thickness. This was not an issue for us in the past, until we started using Pb-fr
Electronics Forum | Wed Aug 09 22:00:44 EDT 2000 | Dave F
Hey Charles!!! Where in earthly heaven did you get a TO263 with "large solderable tab (approx 8mm square) on the back and 5 leads"? All the TO263s that�ve reached-up and smacked me have been "TO220s" with a modified tab and three leads that are f
Electronics Forum | Tue Feb 20 18:04:53 EST 2007 | coop
I am not familiar with the YV100XG pick & place but you might want to increase the mount height of these components The double stick tape isn't as thick solder paste. it might be pushing the component too far down causing it to twist. I encountered
Electronics Forum | Sat Feb 17 14:21:54 EST 2007 | Muhammad Haris
Hi All, I am using YV100Xg YAMAHA Pick and Place Mounter Machine and I am facing a tilting problem of PLCC 84 and QFP 240 pins ICs. I deeply checked about their vision files and place them on the double sided tape and found them ACCURATE on their pad
Electronics Forum | Thu Oct 05 11:59:51 EDT 2006 | Mario Scalzo, SMT CPE
Good afternoon all! Theoretically, there should not be any issues soldering to the SN100C as the tin content of the molten paste alloy should wet to the finish with no problem. I would just ensure that the peak temperature of the joint is above the
Electronics Forum | Wed Jun 04 21:11:11 EDT 2014 | isd_jwendell
This style gave me grief as well. The problem is the way the part is manufactured leading to an unusual pad configuration. When the part is placed on the PCB there is no pad wrap under the part, the pad is 90 degrees to the board. The datasheet shows
Electronics Forum | Fri May 30 20:03:14 EDT 2014 | hegemon
Starting with the manufacturers layout is a good start. Tilted parts, bad solder joints, sounds like a wetting issue and the board or the parts. Insufficient solder sounds like the printing process needs some attention. We have used this part in th
Electronics Forum | Mon Jul 18 12:24:53 EDT 2016 | oleksz
Some people involved in PCB assembly process claim that SMD components reflow soldering problems are often caused by traces running under a component. According to this claim, trace (or any copper) covered by solder mask and placed under SMD componen
