Electronics Forum | Thu Apr 09 18:55:49 EDT 2009 | gregoryyork
seen it many times before when the resist is not cured at manufacturing. get PCB man to check with K type thermal couple that boards ARE in fact cured. this is normally 155C ON board temperture not oven setting Cheers Greg
Electronics Forum | Thu Apr 09 21:21:11 EDT 2009 | qualityguy
Hello, another SME is saying the solder resist cure level is suspect. I have had a industry SME make reference to this too. Adjusting the cure of the resist changes the surface energy
Electronics Forum | Fri May 28 09:55:36 EDT 2010 | ccouture
What is the humidity level in your facility? We maintain ~40% year round and never have any issues regarding ESD from cover tape peeling.
Electronics Forum | Thu May 27 07:04:42 EDT 2010 | dervinsanjose
Anybody who could help me what is the tape peel off speed of PANASONIC CM602 for 8mm feeder? Appreciate your feedback.
Electronics Forum | Wed Aug 25 17:48:08 EDT 2010 | fdr4prez
Hey, great, thanks! Now I can check with my machine maker and see what their feeders are spec'd to. I may send a reel of parts out to be tested, too.
Electronics Forum | Fri Jun 01 06:40:39 EDT 2012 | umar
Hi Norman... Thansk on yoru input, actually my adhesion test conduct is after pass of IC test. MY IC Test is shown a good result but when go into teh Test adhesion coating then during peel off test my board was failed.
Electronics Forum | Mon Aug 06 07:15:14 EDT 2012 | reypal
Hi to everyone in this forum. I came across this problem recently. Im not sure how it started and its rootcause. The chip resistor termination has been peeled off. Thanks in advance for all your advise.
Electronics Forum | Wed Jun 19 12:06:20 EDT 2013 | rgduval
We only reapplied in areas where significant wear was observed. As I mentioned, shop chairs moving back and forth, combined with lead trimmings and other debris led to scraping and peeling over time. Other than that, no, we did not re-apply over
Electronics Forum | Fri Jul 04 06:49:41 EDT 2014 | padawanlinuxero
Hi We had the same problem but it turns out the problem is with the supplier we use a water base flux too, supplier change the solder mask and it work. cheers!
Electronics Forum | Fri Jul 24 16:39:16 EDT 2015 | cnotebaert
have done it in the past, used silicon as it will flex,, however its not the most robust material! tends to peel/flake off.