Electronics Forum | Sun Feb 27 05:58:06 EST 2005 | raj_nz
YV100XT pick and place machine keeps on coming up with FLYING NOZZLE ERROR...any ideas whats the cause
Electronics Forum | Thu Feb 06 10:13:17 EST 2020 | philc
We use an AOI machine to check the first-off. This will pick up such errors, and if the line is stopped until the AOI operator has approved it, the problem is solved, although it would require one fix.
Electronics Forum | Thu Aug 05 17:19:26 EDT 2021 | cyber_wolf
Will it pick up an A13 or A14 ?
Electronics Forum | Tue Oct 30 03:02:03 EDT 2018 | robl
No issues with the OS, it is called VIOS. Good spares support from China, also should be good USA support as there are a fair few machines there. Assembleon has a website for USA spares, including a lot of the old Yamaha machines. Personally, I
Electronics Forum | Sun Oct 09 20:40:28 EDT 2011 | Jacki
Hi We found the misalignment sometime during SMT 0402chips. So, we made the pick up speed a bit slower then the condition was better however it was time-consuming and delay shipment. We r using Yamaha 100Xg SMT M/C and no probelm in mounting 0602 o
Electronics Forum | Sun May 23 21:33:42 EDT 2010 | ashley
"The part is picked up and head goes to it's xy location" Hello mickd, I believe VP had passed but machine is confused how to compensate & place. OS error normally associate with a faulty VME card. Please check the following :- VM1152 VM1730 VM193
Electronics Forum | Mon Oct 31 23:34:30 EDT 2011 | haiae
Dear All, I bought a used Contact 3AVX some months before. The machine run seem be good until last week I meet a problem as follows: - Head one(Left side) does not pick up components (0805 only) any more after pick good about 10 components. Spindles
Electronics Forum | Thu May 09 10:37:35 EDT 2019 | slthomas
Disclaimer - I know nothing specific about MPM printers. First, a question - have you successfully printed or programmed a print cycle for any other board yet, or is this the first one? I ask because a board stop sensor error sounds like it could b
Electronics Forum | Fri Sep 22 15:35:14 EDT 2006 | lheiss
Hello all, Finally ready to run my first 14 up array and the machine picks up the part moves to the placement location, them moves to home and drops the part. The Z axis never moves. I do get a "run error 1" at about the 4th placement (if it was a
Electronics Forum | Tue May 18 09:58:17 EDT 2021 | kumarb
Thank you so much for the advice. We were suspecting blockage but know that we have clean nozzles. Did the air blow out and removed a spot of black matter - perhaps what was an old o-ring? Nozzles are 61 and 62 posing the issue. Our tech said that 64