Electronics Forum | Wed May 04 19:38:57 EDT 2022 | mikevb
I have a used MyData My9 machine that I've picked up recently and it has a problem with initializing that I can't figure out. It just gives an error stating "no z indicator value at all". I've replaced the flex board with the force sensors but that d
Electronics Forum | Wed Oct 15 15:08:05 EDT 2008 | mbrunton
I have a Fuji IP1 using the MCS control system. Everything works fine, but it seems to have tons of problems placing PLCC4 parts (Osram Power TopLED). Some reels I load up it will give a vision processing error for about 1 out of 10 parts. Other r
Electronics Forum | Mon Apr 28 18:34:17 EDT 2003 | Brian W.
We typically do not try to pick up and hand placve chip resisstors and capacitors. The risk and cost is too high for components that are a penny or less. We take into consideration that on many of our components, someone will have to test them to v
Electronics Forum | Wed Jan 31 13:00:43 EST 2007 | bvdb
The continuing saga - we got the IP-1 communicating with the MCS16 again by replacing a couple of chips on the VME1152 CPU board and now it's working again but have a new problem. The machine stops about every other time when changing nozzles with a
Electronics Forum | Mon Apr 25 20:54:25 EDT 2011 | veeckm
Hello, First of all I am new to the forum and surface mount machinery in general. The machine in question has a problem picking parts correcly. The main problem seems to be that the camera and actual head location is out of calibration? If I do a ru
Electronics Forum | Mon Oct 31 23:34:30 EDT 2011 | haiae
Dear All, I bought a used Contact 3AVX some months before. The machine run seem be good until last week I meet a problem as follows: - Head one(Left side) does not pick up components (0805 only) any more after pick good about 10 components. Spindles
Electronics Forum | Wed Aug 27 12:38:48 EDT 2014 | fuji_user_2014
We do a lot of low volume prototypes and several boards that have have cut outs or fixtures that dont always reliably stop squarely at the in carrier (beveled corners). This sometimes results in a fid read error, because the fid wont be in the search
Electronics Forum | Fri Nov 30 18:27:32 EST 2007 | jmelson
This doesn't help the original poster any, but does the Quad have any sensing of what is going on in the feeder? On the pneumatic or mechanical Philips feeders, if the tape jams in the feeder for some reason, the head just keeps tapping the lever an
Electronics Forum | Tue Mar 13 19:27:33 EDT 2018 | maustin
I have an old Zevatech 740 machine that, until recently, was running well. In the last few weeks, the RH head has started giving me issues. When it picks up a component (and early on in most of my programs it will be picking up chip resistors or ca
Electronics Forum | Thu Sep 12 18:37:09 EDT 2002 | tiusa
Hi Tony, as you might guess, a Nozzle Mfg. has stepped into this conversation. Having worked with many small, mid-size, and Fortune 500 companies for almost 15 years we have seen many "parts" pick up challenges. We were the first to offer "Complia
