Electronics Forum | Tue Apr 03 06:08:11 EDT 2012 | rpa
Hi, where can i place a manual tray feeder on OPAL XII - Assembleon. I tried to put the tray on rear side feeders positions and teached components array positions but an error occurred "software outlimits".
Electronics Forum | Tue Jun 09 16:29:03 EDT 2020 | dilogic
Since rear feeder bank can be in three different positions, machine must know which one it is. Check in Machine Setup, Parameters - Feeders (see attached image). It that's set wrong, machine will try to reach position out of range and will hit end sw
Electronics Forum | Wed Aug 09 19:14:41 EDT 2023 | solderingpro
In today's fast-paced manufacturing landscape, Surface Mount Technology (SMT) factories are seeking ways to enhance efficiency and flexibility while maintaining high-quality standards. The evolution of Autonomous Mobile Robots (AMRs) has provided an
Electronics Forum | Wed Oct 22 06:06:54 EDT 2008 | stanyserrao
1CA64011 and 1CAFE011 UsedBy Display 1CA??011 Cause The Vision_type in part data is expressed using hexadecimal notation ("??"). If "??" equals 1E, 64, 78, 79, AC, or FE then boundary detection could not begin because the nozzle was bent.
Electronics Forum | Wed Mar 20 14:05:29 EDT 2019 | alexcouto
Hello again, I put the motors 1 and 6 back in their correct positions, but head 1 now gives me a new error. will it be necessary to configure the head 1 motor in any way? I was still checking to see if the belt and the engine would be in position, bu
Electronics Forum | Fri Nov 17 09:29:27 EST 2000 | CAL
Some more information is needed. Is there a machine error indicating a mispick? Or a vision error Component missing? I am not as familiar with UIC machines as I am with Siemens but here is my $.02 anyway. Try shimming the feeder under the pick up pos
Electronics Forum | Fri Jul 13 05:52:52 EDT 2012 | mjscottinnc
I have a tp18 which gets a non-repeatable end position error, anyone else have this error? What should I look at?
Electronics Forum | Fri Feb 10 12:21:20 EST 2023 | youngbuck
Also, tried swapping the Servo card. X7 which is the Rising table servo motor card, swapped with X8,9,10 which are all the same and same result.
Electronics Forum | Fri Apr 14 13:54:36 EDT 2023 | proceng1
Can you post a photo of the position of the cutters when the error occurred? Also, where are you located?
Electronics Forum | Sat Apr 15 18:34:10 EDT 2023 | dskling
Hi. Thank you for reaching out. See below for pictures. When you turn the machine on this is the position the cutters are in, the error comes up immediately. I am located in South Jersey.