Electronics Forum | Thu Mar 02 04:24:46 EST 2006 | walbone
Hi, We have recently purchased a Quad IVC 115 pick and place machine but are finding it difficult to place SOT23 and similar components. The Visual alignment system rejects the components. We have manually measured and also got the system to measure
Electronics Forum | Wed Nov 21 15:37:46 EST 2007 | afm
We have been looking for an old machine (budget issues), and we have foud Juki 570L and Quad IVc to be around same cost. I have found some comments on the forum for the Quad (good in general), but not too much for the Juki. Beside the expected issues
Electronics Forum | Tue Apr 19 14:58:05 EDT 2011 | rdoss
The ribbon cable would be my guess. I ran a IVc for about 3 years and we use to have to change out our cable at least once per year. I also wanted to add that you can contact Precision Placement Machines (PPM) for parts and service. We use to use
Electronics Forum | Mon Apr 01 13:47:38 EDT 2013 | microaide
Anyone know how to use AutoProgram 5.32 for the Quad IVc assemblers? I am having all kinds of problems. I can't create a new SMD Type because the Edit menu is greyed out, so I can't select New. I can't figure out how to set up feeders and assign feed
Electronics Forum | Tue May 07 09:32:39 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Tue May 07 09:33:04 EDT 2013 | ngineer
Yesterday, my Quad IVc was on, but not running. There was a power fluctuation. I immediately got a motor err #5. I checked all the doors were closed, tried to home / reset the machine, and then turned it off and back on. Neither breaker was trip
Electronics Forum | Mon Jul 06 06:51:50 EDT 2009 | leemeyer
Many years ago we purchased a IOmega ZIP drive that would connect to the parallel port of the computer. They have a utility called "guest" that we installed on all of the IVC computers. We were then able to connect the drive to the parallel port and
Electronics Forum | Wed Feb 27 12:38:49 EST 2002 | stmerkt
Tyco has recently completed development work on the ThinPRO feeder. This feeder provides exceptional performance for 0201 and 0402 applications. The feeder is compatable with the IV-C, QSV, QSX, QSP-2, and APS platforms.
Electronics Forum | Fri Mar 11 09:32:03 EST 2005 | ???
change the x/y ribbon cable's.....you will probably find one of those are going bad. good luck
Electronics Forum | Mon Mar 14 10:42:23 EST 2005 | ???
oh....bye the way....there are dip switches on the driver cards that need set correctly when swapping them.....i hope you set the correct switches when swapping or you probably will never get it to work.