Electronics Forum | Wed Dec 13 14:17:26 EST 2017 | emeto
For the ovens you run the profiler and you compare graphs. For the AOI you should run these golden boards(boards that you keep for AOI test - might have intentionally implemented defects) once in a while and make sure you are getting the same results
Electronics Forum | Thu Jan 04 03:01:38 EST 2018 | buckcho
As always, our good colleague Evtimov is right about the AOI and oven. For the AOI you need to make a golden sample board(panel) and test if your machine can catch all defects that you simulated BEFORE the oven. Try to me as accurate to real defects
Electronics Forum | Thu Sep 05 23:18:03 EDT 2013 | feiyangniao
There is a new toy I received today: a NeoDen TM-240A automatic desktop pick and place machine! I’ve kept my eyes on this baby for a quite a while, and finally decided to make a purchase last week. The shipping was very fast: DHL from China, a total
Electronics Forum | Mon Sep 23 18:11:10 EDT 2002 | steveb
On an assembly reflowed in air saw the same thing: 0201's with a grainular solder joint, but 0402's and above with perfectly formed joints. Reflow profile all within acceptable tolerances. Reflowing in nitrogen solves this problem, but increases t
Electronics Forum | Tue Feb 19 16:19:26 EST 2008 | edatasys
Check out http://www.solderstar.co.uk/wavePro.html This tool measures all key wave solder information with a single pass. Wave/PCB contact, immersion depths, etc. Also has a reflow pack to allow use on reflow, 9 channels with predictive software. B
Electronics Forum | Mon Mar 26 09:41:03 EDT 2018 | fuji_user_2014
Hi Gurus, Looking for alternatives to line makeup after reflow oven. Currently, I have a continuous on flat belt conveying out of my reflow oven straight to an EOL bench. The operator manually picks up the board off the belt (there is a roller at t
Electronics Forum | Tue Feb 08 12:36:28 EST 2000 | Charlie
I'm looking for information from both those who do cure glue and reflow past with the same profile and those who have tried and decided against it. What were the problem? What are the limitations?
Electronics Forum | Wed Jun 05 21:33:12 EDT 2002 | davef
Tough to say based on what you have told us. Things to Determine are: * Is the heat at the solder connections that are not reflowing properly adequate? * Is the pad surface of the solder connections that are not reflowing properly solderable?
Electronics Forum | Tue Jan 04 08:02:54 EST 2005 | Mike
Hi!! Where can I get information about Post- and pre-reflow rework? Some links, opinions?? Please Tell me? I would like to know too some methods and cost effective ways,that how we can rework repair printed boards? Thanks!!
Electronics Forum | Mon Jan 24 06:15:38 EST 2005 | David
Hi everyone! Is here anyone, who has experience about closed-loop feedback (AOI) with Pre- and post-reflow rework. I need too some internet links, whic handle by this subject. Thanks!!!
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, USA
Phone: 5102268155