Electronics Forum | Thu Dec 14 04:42:11 EST 2017 | jineshjpr
Can anybody suggest how can I achieve good solderability in convectional reflow oven If I reduced Convection Air Speed 80%. The whole purpose is to reduce 0402 LED tilting in the convectional reflow and the PCB having QFN with 60 to 120 sec soak, 30
Electronics Forum | Thu Jul 10 10:25:05 EDT 2008 | gregoryyork
I guess the paste is Leaded hence the 220 Peak temp and the Sn100c is Eutectic at 227C so you need to be hotter to melt the HASL finish or you are relying on it alloying together with the paste which takes much longer. suggest running peak temp of 23
Electronics Forum | Wed Oct 04 16:14:17 EDT 2006 | inds
what is your peak temp.. if you try to go too high say 225-230 deg C there is a fair chance of seeing voids.. depending on your ball size and paste volume you can get a good collapse at temps below 225deg C...
Electronics Forum | Wed Oct 04 16:30:12 EDT 2006 | russ
I hope you are not trying to melt the Ceramic BGA columns. these are not meant to melt. I would run a lead process at peak temp of 225 -230C with lead paste. The board warpage may be of design issue or Manufacture issue. Russ
Electronics Forum | Thu Oct 05 16:06:33 EDT 2006 | cw
Thanks! What's your ramp rate?2 - 3C/sec? What's your time above 217C. What's your peak temp?
Electronics Forum | Tue Jan 31 12:13:26 EST 2006 | Calvin Kolokoy
Today's regular Sn-Pb paste chemistries are designed to run at higher peak temperatures ensuring that your lead-free alloys will coalesce with your regular Sn-Pb solder. That being said, it is do-able to solder both types in one oven. Generally, wit
Electronics Forum | Wed Feb 01 06:02:59 EST 2006 | joe
Hi, SAC BGA's in a SnPb reflow process can be achieved by ensuring the temp. on the BGA is at a peak min of 220�C and a time above 207-210�C for 60 - 90 Sec. Lower temperatures have shown incomplete mixing of alloys and some voiding.
Electronics Forum | Tue Jan 31 12:02:22 EST 2006 | aj
how would you apply both pastes.? anyway, I have succesfully run leadfree bga with lead paste. You gotta find a profile that kinda meets both requirements. Taking into consideration the peak temp and time above. dont have details on hand but I ca
Electronics Forum | Thu Oct 13 18:20:14 EDT 2022 | proceng1
I also believe it is the cause of the issue. I guess you could make a fixture that clamps the board flat. Then you'd have to change the reflow recipe. How was the recipe created? Did you actually profile a populated board or just use a recipe that
Electronics Forum | Fri Oct 06 08:21:26 EDT 2006 | inds
Mario, what happens when there are components on the boards that are not rated to take temperature of 230-240 C Peak for a mixed assembly. I guess there are tons of sn/Pb components that have rated temp of 225-230 C.. So in guess you might want
