Electronics Forum | Wed Jan 03 19:12:09 EST 2007 | Mike F
If I could set it up for markers and leave it I probably would not be as frustrated with the printer. We also run polyimide labels through that same printer, which means you have to adjust that sensor to a different position. Then when we switch back
Electronics Forum | Wed Mar 21 06:01:07 EDT 2012 | hunzo
Hello Sergey, I have used Kirsten Modula Wave with ADL (anti dross liquid) option. We have had the same expectation like you: less dross and lower operation cost due to no inert gas is required. That is achieved, the dross generation was modest and t
Electronics Forum | Fri Jul 09 17:52:43 EDT 2021 | glasscake
Hello, I have a Topaz-X that is losing its R origin as it runs. The issue can be seen in the following test: Set the machine to ignore vacuum/ignore alignment and have no feeders in the machine also set the nozzles all to fixed. I run a servo orig
Electronics Forum | Wed Jul 11 14:45:22 EDT 2007 | samir
ECD, KIC, or any mfgr. of thermal profiling devices will charge a premium for "simple stuff". For example, ECD charges a grand for their "flux-o-meter", which is just a PCB with a hole pattern, a pallet, and pH-sensitive paper. You can easily ma
Electronics Forum | Thu May 02 15:29:19 EDT 2013 | jim_n_hky
I can't answer your specific question on the floor, but I have some suggestions. The equipment manufacturer should be able to provide the floor loading requirements. A structural engineer should be able to translate that into specs for hte constructi
Electronics Forum | Fri Feb 07 13:17:32 EST 2020 | bk
I am assuming you are initializing each motor individually through the service program. The z motor theta is hard to see so I put a mark on it with a colored marker so you can watch if the midas tool nozzle is actually turning or not. You should be a
Electronics Forum | Tue Jan 05 21:24:34 EST 2021 | rmitchell
We use to have to replace the "dog" tube when it got rounded out or worn a little. If you you already cleaned it and can see the red light going off and on when you gently push up on the nozzle it is just not seeing in time and it gives the nozzle c
Electronics Forum | Tue Mar 28 19:17:17 EST 2006 | daxman
Hi guys, Sorry I haven't posted in awhile...but here are the details.. The noise in the cam box is the C-axis coupling. (Sr.Tech was right) Applying a little oil to the coupling pins killed the noise, but cam back in a few hours. We are in the proce
Electronics Forum | Sat Sep 16 12:49:36 EDT 2006 | magszoo
I'm hoping that someone may be able to shed some light on this error we've been getting on our DEK 265LT printer. Several months ago we began getting a "Rising table position error" after the operator would open the hood to load paste or after changi
Electronics Forum | Sat Aug 24 08:01:28 EDT 2002 | kumarraju
Hi CS Tan, Most customers expecially tend to neglet maintenance of the machine. As in the case of Dek 288 most of the end users have the impression that the 288 is one of the worst machines by Dek. But till today although Dek has discountinued manufa
Industrial Sensor Vision International specializes in advanced camera technology of high resolution fast speed cameras for automation, AOI, 2-D/3-D, SPI inspection and wafer inspection.
3 Morse Road 2A
Oxford, CT USA
Phone: +1 203 592 8723