Electronics Forum | Sun Feb 11 21:56:20 EST 2018 | asvimani
Once i switch on the cm-402(panasonic) mounter machine, it directly shows the following error-"take down the PCB support table". i tried changing card no-5 for I/O. Please help me by providing suitable solutions for the above threat. thank you...
Electronics Forum | Sun Apr 17 18:22:18 EDT 2022 | dekhead
Please clarify what you mean by "bouncing". Small up and down motions around home position? Full stroke of table movement up and down? Or somewhere in between? Does it start as soon as servo power is applied? Or not until table home movement is initi
Electronics Forum | Mon Aug 06 10:03:01 EDT 2007 | slthomas
I agree with jdengler on the rotary table being skewed. You need a couple of dowel pins (1 1/2" long x 1/4" dia., I think) to align that disk. Each idler is held on an eccentric cam and can be adjusted to square up the rotary table by dropping the do
Electronics Forum | Sun Jul 05 12:32:43 EDT 2009 | emanuel
While moving to a new location we had to remove the tables from a Philips Comet in order to be able to pass a narrow door. While attempting to calibrate the machine, during Warm-Up a strange error appears, sometimes almost immediately and sometimes a
Electronics Forum | Wed Mar 20 13:49:15 EST 2002 | cabjerk
Hi All; The following is from our Support people who worked with Fuji on the problem; Last week Luke Mittur and John Gudel were in from Fuji to address the IP3 issue outlined below. The problem ended up being that the table "up" and table "dow
Electronics Forum | Wed Mar 01 17:13:15 EST 2000 | Dave F
Sorin: Formulas for calculating heat dissipation of traces don�t seem to provide practical results. But there are some wonderful tables and graphs that will meet you needs. You may need to do some finagling when calculating vias and through holes,
Electronics Forum | Wed Mar 01 17:13:15 EST 2000 | Dave F
Sorin: Formulas for calculating heat dissipation of traces don�t seem to provide practical results. But there are some wonderful tables and graphs that will meet you needs. You may need to do some finagling when calculating vias and through holes,
Electronics Forum | Mon Jun 19 10:10:18 EDT 2006 | rmitchell
Hi, Our CP6-5 has a Z overflow error when trying to zero set. The table moves in X and Y and almost zeros prior to the Z overflow. Servo Amp? Rob
Electronics Forum | Mon Jun 19 21:25:47 EDT 2006 | Chris
Try raising the table in Calibrate mode. Sensor or Tactile connector could be contacting the underside of the rails and overloading the axis. Check for 24V on the Z-axis brake. Check the fuse(F5) and voltage to the driver. Check DIP switch settin
Electronics Forum | Fri Jun 04 09:31:48 EDT 2010 | thanh
there are 2 rail lift sensors at left and right of the table, maybe need to clean or re-adjust.