Electronics Forum | Mon Sep 16 00:30:56 EDT 2013 | larrygroves
likely something loose in the z or theta axis. Motor overruns and is corrected but goes too far then gets corrected back. it sets up an vibration and can make a lot of noise. best guess is that the spring is broke in the z rack.
Electronics Forum | Sat Mar 22 17:08:13 EDT 2014 | pdl
i can send you some of the manuals but i dont hae an operators manual would need a email address cheers Pete
Electronics Forum | Thu Jan 21 07:03:43 EST 2016 | anel_elektronik
I have it: "Inline Before Input" have to be closed. Conveyor Board CP35. Greetings
Electronics Forum | Fri Jun 09 07:32:13 EDT 2017 | bukas
it sounds to me like a home sensor. try adjusting sensitivity if possible. move head manually to determine position at which home sensor is activated
Electronics Forum | Mon Jun 12 11:14:10 EDT 2017 | bobpan
Sounds to me like the z-encoder could be a problem. I cant remember but you may be able to disable a head in the system settings. Bob
Electronics Forum | Wed Jun 21 21:28:34 EDT 2017 | maddy
Hi We had same issue with Head 2.if you find solution let me know as well. thanks
Electronics Forum | Wed Jan 23 07:42:34 EST 2019 | rolfi
Hi, we had the same issue with our CP30V and head1. Did you solve the problem? Please let me know as well. Thank you.
Electronics Forum | Thu Jan 24 09:09:46 EST 2019 | protokos
Hi Kathy i had the same issue yesterday and find that a spring is not ok. and i also clean the sensors this was fixing the problem for me.
Electronics Forum | Thu Jan 24 12:09:08 EST 2019 | palsrvs
Wil, Thank you so much! So appreciated!! The spring makes sense. We will check these items.
Electronics Forum | Wed Feb 07 12:21:06 EST 2018 | kahrpr
Its been a long time but there is a file called ERROR.dat there should be one called erroreng.dat or something like that just rename that file error.dat