Electronics Forum | Mon Jul 08 13:10:55 EDT 2013 | rgduval
As with any issue like this, your miileage may vary with suggestions....but, here are the items I would consider: 1. Clinch tightness. I believe IPC gives a recommendation on the amount of bend in a clinched lead; make sure you're not beyond that.
Electronics Forum | Thu Dec 21 21:37:19 EST 2006 | Jack
Hi Pavel, Real Chunks, Thanks for your valuable inputs..Selecting the correct location for board profiling is critical in determining the solder joint quality. Am I right to say TC wire attachment locations priority should be as below: (1) Thermal
Electronics Forum | Tue Jun 20 17:56:39 EDT 2000 | Gary Kemp
Can anyone give me a ballpark figure on where to set the temperature for the pre-heaters of a wave solder? Any responses are greatly appreciated.
Electronics Forum | Mon May 16 18:03:30 EDT 2005 | davef
Key Issue: Will this machine solder your boards? You never know until you solder one. Any other avenues of analysis involve substantial risk. Flux Selection * High or low solids * VOC or VOC-free Solder Alloy * If using lead-free, avoid stainles
Electronics Forum | Thu Mar 04 10:21:55 EST 1999 | Igmar
Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just a rec
Electronics Forum | Mon Mar 08 16:23:24 EST 1999 | Dave F
| Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? | | Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just
Electronics Forum | Sat Mar 06 08:01:45 EST 1999 | Scott Cook
| Can someone please advise me to the rework procedure for removal and replacing Ceramic Chip Capacitors (e.g. 0805, 1206, etc.)? | | Is it necessary to pre-heat ceramic capacitors before soldering them onto a PCB with a soldering iron? Is this just
Electronics Forum | Fri Apr 21 14:58:04 EDT 2023 | rgduval
I mean...there are a ton of possibilities for bridging on selective solder before you ever get to alloy purity. Are the bridges happening consistently in the same spot? Are the leads too long? Can you modify the approach/exit/peel off to address? Wh
Electronics Forum | Fri Mar 21 15:51:23 EDT 2008 | g2garyg2
Thought I would reply and try to assist. PROMATION, my company, also manufactures Diode Laser soldering systems but with this stated we also manufacturer iron tip systems, soft beam systems and hot air solutions. The reasons are simple. Diode Laser
Electronics Forum | Fri Oct 22 19:07:29 EDT 2010 | jry74
To get out of a delivery pinch, I had to pre-tim some connectors because of contaminated leads. Make sure your selective wave speed and XYZ travel are close. Try doing a dry run across the board to preheat the PTH and then go back and solder them.
.gif)
