Electronics Forum | Mon Jan 21 06:58:41 EST 2019 | kiransahu
Without PCB layout, not much would get done. It is a ubiquitous need across industries; Industrial, consumer, military...Everywhere you look, there are chips soldered to PCBs to create a final product for the end customer. But where did we all learn
Electronics Forum | Mon Jun 21 12:57:10 EDT 1999 | Earl Moon
| | I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something),
Electronics Forum | Mon Jun 21 13:02:59 EDT 1999 | Earl Moon
| | | I dug through my big box of office crap and found the disk with my technical papers. I posted the one on process control in the SMTNet library. It covers a lot of ground on what causes defects in the wave (too much or too little of something)
Electronics Forum | Fri May 07 17:02:01 EDT 1999 | Earl Moon
| On 1.27mm (0.050 inches) Standard Ball Grid Array's. | The ball size diameter starts at approximately 0.025 inches. | | If the ball size decreases to 0.012 inches (due to the solder flowing down a via) is the solder connection reliable? | | This
Electronics Forum | Thu May 13 18:36:55 EDT 1999 | Andrew Wulff
| | On 1.27mm (0.050 inches) Standard Ball Grid Array's. | | The ball size diameter starts at approximately 0.025 inches. | | | | If the ball size decreases to 0.012 inches (due to the solder flowing down a via) is the solder connection reliable? |
Electronics Forum | Sun Mar 12 01:58:44 EST 2006 | grantp
Hi, We have been soldering lead free BGA's onto products with lead based paste, and we have had no increase in defects at all. We have used a standard lead paste profile, so we are not altering the temps anything from what's recommended by the paste
Electronics Forum | Mon Jun 28 11:47:54 EDT 1999 | Christopher Cross
| | | hello, | | | | | | has anyone tried dispensing solder paste in thru holes instead of waving or hand soldering. if so how did it work out for you. | | | thanks for the input | | | | | | wayne | | | | | | | | | | | We have tried this mainly
Electronics Forum | Fri Jun 26 08:58:43 EDT 1998 | Justin Medernach
| WHAT IS THE BEST ANGLE FOR THE SQUEEGEE BLADE TO BE ANGLED AT? WE ARE USING 45 DEGREE ON OUR POLYURETHANE BLADES, AND I BELIVE WE HAVE THE OPTION OF EITHER 45 OR 60 DEGREES ON OUR METAL BLADES. WHICH OF THE TWO IS BETTER, OR SHOULD WE BE USING AN
Electronics Forum | Sat Jun 27 08:23:02 EDT 1998 | Dave F
| | WHAT IS THE BEST ANGLE FOR THE SQUEEGEE BLADE TO BE ANGLED AT? WE ARE USING 45 DEGREE ON OUR POLYURETHANE BLADES, AND I BELIVE WE HAVE THE OPTION OF EITHER 45 OR 60 DEGREES ON OUR METAL BLADES. WHICH OF THE TWO IS BETTER, OR SHOULD WE BE USING
Electronics Forum | Thu Apr 16 13:50:49 EDT 1998 | Lou
| We are having some difficulty soldering a 240 pin Altera device. We use Alpha WS-609, a very generic profile for that solder paste, and a 6 mil stencil with laser cut apertures (1:1 ratio). This is a 20 mil pitch device (aperture size is 10 mils X
