Electronics Forum | Tue Dec 13 18:30:46 EST 2011 | IT23
Currently, we are using fixed barcode scanners that connect to Cogiscan PFC box. The scanners are mounted using a flexible arm. The flexible arm is hard to adjust so that the scanner will be on top of the label every time it hits the sensor. I'm look
Electronics Forum | Mon Oct 09 06:04:47 EDT 2017 | bobpan
Hello Joyce, Usually I use Very Large cable ties and secure the heads in the opposite corners. I also tie up the z rods or put some plastic tube under the top portion to keep them up. Remove the monitor and bracket off the side of the machine...and i
Electronics Forum | Thu May 13 19:41:17 EDT 2004 | johnww
Hi Everyone, I want to use LEDs in an enclosed box for edge lighting etched glass. There are 15 LEDs in a box and they are set up in 5 series of 3 LEDs. The LEDs are 3.5V 20Ma 8000mcd. I've worked out that I need an 82 ohm resistor for each series
Electronics Forum | Tue Apr 21 12:48:13 EDT 2009 | bk
ok you verified that the motor was bad. So now i would go back and verify that your voltages are still good on the back of the computer box and on the booster board. If they all check out fine. I would take the mot x board from your working machine a
Electronics Forum | Tue Sep 11 11:50:41 EDT 2007 | brulal1
Went we buy our Panasonic line we have the DSM, I never use it because we do mix several PCB on the same set-up and want to produce top a bottom on one PCB before switching on another one, DSM don't work that way He will optimize all the PCB so we wi
Electronics Forum | Mon Mar 16 08:34:46 EDT 2009 | sachu_70
Hey Loco, how about saving the bottom side? It actually only depends on your oven setting specific to Top heaters and Bottom heaters. Unless you set the parameters rightly, you would face such issues. It only indicates that you need to seriously re-l
Electronics Forum | Tue Aug 13 11:21:04 EDT 2019 | slthomas
A profiler can't distinguish where your heat is coming from, so if you're significantly imbalanced between top and bottom heat (could be an oven problem or your settings) it might still be a cause. You don't say whether or not your top and bottom s
Electronics Forum | Tue May 09 14:56:43 EDT 2006 | JW
An option to consider is leave top and bottom heaters settings the same; to get correct liquidus time and temperature on one side, you will have some amount of reflow on the second side. If you have BGA's, QFP's on the bottom side yet they are smalle
Electronics Forum | Fri Mar 04 10:54:07 EST 2016 | huske
I doubt your machines dirty or calibration is out of wack, unless you beat it up real good. I have had the BX for a few years now and I have personally programmed over 700 recipes. Outside of monthly machine dust wipe downs and re-greasing the y-wag
Electronics Forum | Thu Aug 02 21:22:15 EDT 2018 | davef
I need your input. What are your thoughts? Currently SMTnet is looking to improve process. It uses four different lists of categories that all are maintained and updated separately. A single LIST makes sense. Approaches to arranging the LIST being
