Electronics Forum | Wed Aug 22 16:11:15 EDT 2007 | razor1
If the problem appears to be random... we had a similar problem. We found that the belt which feeds the PCB through the reflow oven would jump or lurch ahead. It was barley noticeable but if you have identified the frequency and time of the compone
Electronics Forum | Tue Dec 28 10:04:01 EST 2004 | Mark
No delta T issues as I am not actually reflowing the component to the PCB. This is for moisture sensitivity testing as per JEDEC 020C Standard. Trying to duplicate a profile in the standard and am having trouble reaching a component ramp rate of 3
Electronics Forum | Mon Dec 27 18:44:14 EST 2004 | Mark
I am testing some BGA's (PBGA 30mm x 30mm) to evaluate the maximum ramp rate we can achieve in our reflow oven. Temperature is being measured at the body(top) of the component / not leads. After several trials (with various oven settings), the high
Electronics Forum | Sun Nov 20 01:27:21 EST 2005 | C. Kolokoy
Try an experiment where you profile the assembly with 3 consecutive boards in the oven spaced just 1" apart versus just 6" apart and then 12" apart. You figure most ovens have about 12 - 16" heating zones, so for your typical 8"x8" PCB, you'd have w
Electronics Forum | Fri Nov 18 15:12:45 EST 2005 | bocci572
Can anyone tell me if there is an industry standard on how much of a space should be between PCB's in a convection reflow oven? Thanks
Electronics Forum | jineshjpr |
Thu Dec 14 04:40:31 EST 2017
Electronics Forum | Thu Dec 14 14:43:54 EST 2017 | kahrpr
Just Curious why would you need to reduce the air speed by 80%
Electronics Forum | Fri Jul 25 23:01:04 EDT 2008 | chip_flip
What paste are using? You should referance the manufactures time and temperature specification. Running lead-free in a 5 zone oven can be done with out a problem but it is not production friendly. If you are concerned with through put I would look fo
Electronics Forum | Thu Apr 29 17:19:59 EDT 1999 | Kevin Hussey
Hi Boys and Girls, I've been given the "task" to turn off the nitrogen in our reflow ovens. I am using the BTU, TRS series ovens, each with eight zones. Also, I have a couple of new BT Paragon ovens with 10 zones. We currently are running Qualite
Electronics Forum | Wed Feb 12 08:10:49 EST 2020 | majdi4
We can't do that because we are using dual ligne reflow oven..So the two sides of PCB are soldered with the same reflow profil.