Electronics Forum | Wed Aug 19 16:28:03 EDT 2015 | mdeley
Looking for a Santa Clara area contract service with capability to attach 15mil dia. solder coated Cu balls, ideally on a 12" x 18" PI panel, small job to start. T&R services are a plus. My initial search is coming up with device/component level r
Electronics Forum | Tue Mar 19 10:27:06 EST 2002 | amir
in regards to repairing all these boards, do they consider the end cost of the product whether it's worth it to do so or not? if it does, would you be able to do it in house? and how labor intense is the job? there are machines out there for mass rep
Electronics Forum | Wed Mar 20 11:14:15 EST 2002 | cfraser
Guy's I am sorry but your dike removal process for chip components is midievil at best. The fastest way to remove a chip is with 2 solder irons. Place one iron on each end of the component. This process is completely safe and takes about 2 seconds pe
Electronics Forum | Mon Jun 19 22:19:40 EDT 2006 | Nathan
Dear All, We plan to setup an assembly line for our small volume production of PCBs (about couple hundred PCBs per week). The board has about 150 components (less than 30 types) and a few BGA and IC (majority is SMT, only few THT connectors). We hav
Electronics Forum | Wed Feb 17 08:49:53 EST 1999 | Brian G Bancroft
Hello all in SMT land: My name is Brian G Bancroft and I work for Lucent Technologies in New jersey. I have been asked to try and find information on a bench top workstation with micro-manipulation ability, soldering capability and binocular
Electronics Forum | Wed Feb 17 17:34:17 EST 1999 | Karl Mighton
| Hello all in SMT land: | | My name is Brian G Bancroft and I work for Lucent Technologies in New jersey. I have been asked to try and find information on a bench top workstation with micro-manipulation ability, soldering capability and bin
Electronics Forum | Wed Feb 17 17:49:26 EST 1999 | Zboss
| | Hello all in SMT land: | | | | My name is Brian G Bancroft and I work for Lucent Technologies in New jersey. I have been asked to try and find information on a bench top workstation with micro-manipulation ability, soldering capability a
Electronics Forum | Wed Feb 17 17:51:37 EST 1999 | Zboss
| | | Hello all in SMT land: | | | | | | My name is Brian G Bancroft and I work for Lucent Technologies in New jersey. I have been asked to try and find information on a bench top workstation with micro-manipulation ability, soldering capabi
Electronics Forum | Tue Jun 20 14:58:22 EDT 2006 | smt_guru
Allow me to make some recommendations. This is my firm's bread and butter, so to speak. Helping startups like yourself achieve their budget objectives, but in the process being innovative and thinking outside of the box. Here are my suggestions----
Electronics Forum | Fri Sep 02 10:10:54 EDT 2005 | Mity-C
We had a customer who came in to discuss a solder adheasion problem on some sub-assemblies we were building for them. When they arrived, they put a sub assembly in a vise and hit it with a hammer. I was speechless to say the least...... C
Golden State is a contract manufacturer that makes wire harnesses, electromechanical assemblies (box builds, subassemblies, PCBAs, kits, etc.) and services (sorting, rework, value additive manufacturing engineering)
18220 Butterfield Blvd
Morgan Hill, USA
Phone: 5102268155
